From: Saeed Bishara <saeed@xxxxxxxxxxx>
The integrated SATA controller is connected directly to the SoC's
internal bus, not via PCI interface. this patch removes the dependency
on the PCI interface.
Signed-off-by: Saeed Bishara <saeed@xxxxxxxxxxx>
---
drivers/ata/Kconfig | 2 +-
drivers/ata/sata_mv.c | 113 ++++++++++++++++++++++++++++++-------------------
2 files changed, 71 insertions(+), 44 deletions(-)
diff --git a/drivers/ata/Kconfig b/drivers/ata/Kconfig
index ba63619..c60842b 100644
--- a/drivers/ata/Kconfig
+++ b/drivers/ata/Kconfig
@@ -69,7 +69,7 @@ config ATA_PIIX
config SATA_MV
tristate "Marvell SATA support (HIGHLY EXPERIMENTAL)"
- depends on PCI && EXPERIMENTAL
+ depends on EXPERIMENTAL
help
This option enables support for the Marvell Serial ATA family.
Currently supports 88SX[56]0[48][01] chips.
diff --git a/drivers/ata/sata_mv.c b/drivers/ata/sata_mv.c
index 97c3e11..cbd3f1b 100644
--- a/drivers/ata/sata_mv.c
+++ b/drivers/ata/sata_mv.c
@@ -421,7 +421,9 @@ static void mv_error_handler(struct ata_port *ap);
static void mv_post_int_cmd(struct ata_queued_cmd *qc);
static void mv_eh_freeze(struct ata_port *ap);
static void mv_eh_thaw(struct ata_port *ap);
+#ifdef CONFIG_PCI
static int mv_init_one(struct pci_dev *pdev, const struct pci_device_id *ent);
+#endif
static void mv5_phy_errata(struct mv_host_priv *hpriv, void __iomem *mmio,
unsigned int port);
@@ -638,14 +640,14 @@ static const struct pci_device_id mv_pci_tbl[] = {
{ } /* terminate list */
};
-
+#ifdef CONFIG_PCI
static struct pci_driver mv_pci_driver = {
.name = DRV_NAME,
.id_table = mv_pci_tbl,
.probe = mv_init_one,
.remove = ata_pci_remove_one,
};
-
+#endif
static const struct mv_hw_ops mv5xxx_ops = {
.phy_errata = mv5_phy_errata,
.enable_leds = mv5_enable_leds,
@@ -665,45 +667,6 @@ static const struct mv_hw_ops mv6xxx_ops = {
};
/*
- * module options
- */
-static int msi; /* Use PCI msi; either zero (off, default) or non-zero */
-
-
-/* move to PCI layer or libata core? */
-static int pci_go_64(struct pci_dev *pdev)
-{
- int rc;
-
- if (!pci_set_dma_mask(pdev, DMA_64BIT_MASK)) {
- rc = pci_set_consistent_dma_mask(pdev, DMA_64BIT_MASK);
- if (rc) {
- rc = pci_set_consistent_dma_mask(pdev, DMA_32BIT_MASK);
- if (rc) {
- dev_printk(KERN_ERR, &pdev->dev,
- "64-bit DMA enable failed\n");
- return rc;
- }
- }
- } else {
- rc = pci_set_dma_mask(pdev, DMA_32BIT_MASK);
- if (rc) {
- dev_printk(KERN_ERR, &pdev->dev,
- "32-bit DMA enable failed\n");
- return rc;
- }
- rc = pci_set_consistent_dma_mask(pdev, DMA_32BIT_MASK);
- if (rc) {
- dev_printk(KERN_ERR, &pdev->dev,
- "32-bit consistent DMA enable failed\n");
- return rc;
- }
- }
-
- return rc;
-}
-
-/*
* Functions
*/
@@ -2578,8 +2541,10 @@ static int mv_init_host(struct ata_host *host, unsigned int board_idx)
mv_port_init(&ap->ioaddr, port_mmio);
+#ifdef CONFIG_PCI
ata_port_pbar_desc(ap, MV_PRIMARY_BAR, -1, "mmio");
ata_port_pbar_desc(ap, MV_PRIMARY_BAR, offset, "port");
+#endif
}
for (hc = 0; hc < n_hc; hc++) {
@@ -2616,6 +2581,47 @@ done:
return rc;
}
+#ifdef CONFIG_PCI
+
+/*
+ * module options
+ */
+static int msi; /* Use PCI msi; either zero (off, default) or non-zero */
+
+
+/* move to PCI layer or libata core? */
+static int pci_go_64(struct pci_dev *pdev)
+{
+ int rc;
+
+ if (!pci_set_dma_mask(pdev, DMA_64BIT_MASK)) {
+ rc = pci_set_consistent_dma_mask(pdev, DMA_64BIT_MASK);
+ if (rc) {
+ rc = pci_set_consistent_dma_mask(pdev, DMA_32BIT_MASK);
+ if (rc) {
+ dev_printk(KERN_ERR, &pdev->dev,
+ "64-bit DMA enable failed\n");
+ return rc;
+ }
+ }
+ } else {
+ rc = pci_set_dma_mask(pdev, DMA_32BIT_MASK);
+ if (rc) {
+ dev_printk(KERN_ERR, &pdev->dev,
+ "32-bit DMA enable failed\n");
+ return rc;
+ }
+ rc = pci_set_consistent_dma_mask(pdev, DMA_32BIT_MASK);
+ if (rc) {
+ dev_printk(KERN_ERR, &pdev->dev,
+ "32-bit consistent DMA enable failed\n");
+ return rc;
+ }
+ }
+
+ return rc;
+}
+
/**
* mv_print_info - Dump key info to kernel log for perusal.
* @host: ATA host to print info about
@@ -2721,15 +2727,34 @@ static int mv_init_one(struct pci_dev *pdev, const struct pci_device_id *ent)
IS_GEN_I(hpriv) ? &mv5_sht : &mv6_sht);
}
-static int __init mv_init(void)
+static int __init mv_pci_register_driver(void)
{
return pci_register_driver(&mv_pci_driver);
}
-static void __exit mv_exit(void)
+static void __exit mv_pci_unregister_driver(void)
{
pci_unregister_driver(&mv_pci_driver);
}
+#else
+static int __init mv_pci_register_driver(void)
+{
+ return 0;
+}
+
+static void __exit mv_pci_unregister_driver(void)
+{
+}
+#endif
+static int __init mv_init(void)
+{
+ return mv_pci_register_driver();
+}
+
+static void __exit mv_exit(void)
+{
+ mv_pci_unregister_driver();
+}
MODULE_AUTHOR("Brett Russ");
MODULE_DESCRIPTION("SCSI low-level driver for Marvell SATA controllers");
@@ -2737,8 +2762,10 @@ MODULE_LICENSE("GPL");
MODULE_DEVICE_TABLE(pci, mv_pci_tbl);
MODULE_VERSION(DRV_VERSION);
+#ifdef CONFIG_PCI
module_param(msi, int, 0444);
MODULE_PARM_DESC(msi, "Enable use of PCI MSI (0=off, 1=on)");
+#endif
module_init(mv_init);
module_exit(mv_exit);
--
1.5.0.6
-
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
