Re: AHCI + ST3160023AS + NCQ problems

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 10/30/07, Michael Tokarev <mjt@xxxxxxxxxx> wrote:
> By the way, did you forget to remove a jumper on the drive
> (the only jumper installed by default) that limits drive
> usage to SATAI?
...
> ..etc.   Try again without the jumper?  Note that NCQ is NOT supported
> in SATAI mode, or there were some pre-standard implementations of it.
> In SATAII, NCQ is standard (well... more or less anyway ;)

Huh?

To my knowledge, the jumper should only limit the bus rate to
1.5Gbit/s, for compatibility with one or more chipsets.  It shouldn't
affect the command set supported by the device.
-
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html

[Index of Archives]     [Linux Filesystems]     [Linux SCSI]     [Linux RAID]     [Git]     [Kernel Newbies]     [Linux Newbie]     [Security]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Samba]     [Device Mapper]

  Powered by Linux