Matti Linnanvuori wrote:
Correct IDEPCI_SHARE_IRQ description to keeping interrupts enabled
when calling the PCI IDE action handler.
Add IDEPCI_SHARE_IRQ and IDEDISK_MULTI_MODE help text from hdparm
manual page.
Signed-off-by: Matti Linnanvuori <mattilinnanvuori@xxxxxxxxx>
NAK.
@@ -154,6 +154,18 @@ config BLK_DEV_IDEDISK
config IDEDISK_MULTI_MODE
bool "Use multi-mode by default"
help
+ Multiple sector mode is a feature of most modern IDE hard
+ drives, permitting the transfer of multiple sectors per I/O
+ interrupt, rather than the usual one sector per interrupt.
+ When this feature is enabled, it typically reduces operating
+ system overhead for disk I/O by 30-50%. On many systems, it
+ also provides increased data throughput of anywhere from 5%
+ to 50%. Some drives, however (most notably the WD Caviar
+ series), seem to run slower with multiple mode enabled. Some
+ drives claim to support multiple mode, but lose data at some
+ settings. Under rare circumstances, such failures can result
The speed increase data provided here are largely useless, since multiple
mode only applies to PIO transfers. At least, the comment should make this
clear...
+ in massive filesystem corruption.
+
If you get this error, try to say Y here:
hda: set_multmode: status=0x51 { DriveReady SeekComplete Error }
@@ -367,11 +379,16 @@ config BLK_DEV_IDEPCI
bool
config IDEPCI_SHARE_IRQ
- bool "Sharing PCI IDE interrupts support"
+ bool "Keeping interrupts enabled when calling the PCI IDE action handler support"
Keeping IRQ enabled is only a side effect of IRQ sharing...
depends on BLK_DEV_IDEPCI
help
- Some ATA/IDE chipsets have hardware support which allows for
- sharing a single IRQ with other cards. To enable support for
+ A setting of Y permits the driver to unmask other interrupts
+ during processing of a disk interrupt, which greatly improves
+ Linux's responsiveness and eliminates "serial port overrun"
+ errors. Use this feature with caution: some drive/controller
+ combinations do not tolerate the increased I/O latencies
+ possible when this feature is enabled, resulting in massive
+ filesystem corruption. To enable support for
this in the ATA/IDE driver, say Y here.
Comments do not really describe the IRQ sharing option anymore.
It is safe to say Y to this question, in most cases.
MBR, Sergei
-
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html