Re: Promise SATA300 TX4: errors, oops in ext3 code

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Alexander Sabourenkov schrieb:
> Hardware:  Athlon64, Asus A8V, Promise SATA300 TX4, 2xSeagate 7200.10
> 320G, jumper-limited to SATA150.
> Kernel : 2.6.22.9 amd64
>
> Problem:
> Heavy load causes errors and triggers oops.
>
> History:
> Problems were first encountered on kernel 2.6.19, both i686 ("old"
> system) and amd64 (gentoo installation CD).
> Can't say anything about older kernels. Most probably they have same
> issues (or worse).
>
> Problems were blamed:
>   - SATA300 being too 'hot'  (jumpered the drives)

Did you turn it back to SATA300 and does it basically still work?
Then cool it actively and see if the error rate depends on it.

In one of my Promise HDD (PDC20275) controller designs I forgot to connect
the thermal pad (they call it E-PAD) properly to a GND plane so it just
worked with lots of errors which were also temperature sensitive (so, a
typical hardware design flaw :-).
On a PCI add-on card with the same chip, the E-PAD also didn't look
soldered over it's whole E-PAD area but it was working.

As you might have noticed, I am more into hardware debugging.
Propably some kernel gurus might have other ideas (related to software).

Regards,

Clemens Koller
__________________________________
R&D Imaging Devices
Anagramm GmbH
Rupert-Mayer-Straße 45/1
Linhof Werksgelände
D-81379 München
Tel.089-741518-50
Fax 089-741518-19
http://www.anagramm-technology.com


-
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html

[Index of Archives]     [Linux Filesystems]     [Linux SCSI]     [Linux RAID]     [Git]     [Kernel Newbies]     [Linux Newbie]     [Security]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Samba]     [Device Mapper]

  Powered by Linux