Joris wrote: > Hello List, > > > I have a rather annoying problem. > On an Intel S3000AHLX > (http://www.intel.com/design/servers/boards/s3000ah/index.htm) > motherboard, I can't seem to utilize all SATA interfaces to the > maximum. > The first sata interface frequently resets every few seconds under > heavy IO, the net result being ridiculous slow transfers (attach: > dmesg_random_collection_of_errors) > > Running debian unstable and it's version of 2.6.22. System contains a > xeon 3210 and an adaptec scsi controller from which I currently boot. > > There is little logic in the symptoms: > * if there is no or light IO, no resets occur. > * it's always the sda port that resets (changing cables or disks > doesn't make a difference). > * only specific combinations of disk-usage on the sata disks (attach: > disk_combinations_causing_reset), just using sda alone does not cause > resets. > * reading is enough, writing is (subjectively) worse. dd > if=/dev/sd{a,b,c,d} of=/dev/null & guarantees trouble. > * when the port resets, the disk makes a clearly audible clicking noise > > I tried numerous things: > * having the board exchanged with intel for the latest revision > (thanks to my hardware supplier), updating to the latest bios and to a > bios version 6 months old. > * booting with older versions of the linux kernel, 2.6.18 and 2.6.21. > * Using all possible combinations of the bios' matrix/lsi fakeraid and > non-raid modes (always ignoring the "raid" and using the disks > directly), and enable/disable the one PATA port in the bios. > * asked seagate for a drive firmware update, to no avail. > > > The only workable solution so far is to leave the first sata interface > unused (remove the disk), which is obviously not a very nice solution. > > Any hints or suggestions would be welcome, I'd be more than happy to > try out new things. > things. I'm a bit at a loss on how to proceed at the moment. Wheee... the link to sda is going up and down (PHY RDY changed) even when sda itself isn't being accessed. I bet the clunking sound is head doing emergency unloading. There are two possibilities: 1. the harddisk is dying or 2. the power which gets fed to the drive sucks (ie. fluctuates too much when other drives suck more power causing sda to do emergency unload and PHY link loss.) You can rule out #1 by exchanging disk positions. You can rule out #2 by connecting the harddrive to a separate PSU or exchanging power connectors to different disks. -- tejun - To unsubscribe from this list: send the line "unsubscribe linux-ide" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
