Use ide_config_drive_speed() instead of pmac_ide_do_setfeature() and remove
the latter, also ide-iops.c::__ide_wait_stat() could be static again.
Since for IDE PMAC host driver IDE_CONTROL_REG is always true, device's
->quirk_list is always zero and ->ide_dma_host_{on,off} are nops than
the only changes in behavior are:
* if PIO mode is set then ->dma_off_queitly is called to disable DMA
* if setting transfer mode fails ide_dump_status() is called to dump status
Cc: Benjamin Herrenschmidt <benh@xxxxxxxxxxxxxxxxxxx>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@xxxxxxxxx>
---
drivers/ide/ide-iops.c | 2 -
drivers/ide/ppc/pmac.c | 79 +------------------------------------------------
include/linux/ide.h | 1
3 files changed, 3 insertions(+), 79 deletions(-)
Index: b/drivers/ide/ide-iops.c
===================================================================
--- a/drivers/ide/ide-iops.c
+++ b/drivers/ide/ide-iops.c
@@ -483,7 +483,7 @@ EXPORT_SYMBOL(drive_is_ready);
* setting a timer to wake up at half second intervals thereafter,
* until timeout is achieved, before timing out.
*/
-int __ide_wait_stat(ide_drive_t *drive, u8 good, u8 bad, unsigned long timeout, u8 *rstat)
+static int __ide_wait_stat(ide_drive_t *drive, u8 good, u8 bad, unsigned long timeout, u8 *rstat)
{
ide_hwif_t *hwif = drive->hwif;
unsigned long flags;
Index: b/drivers/ide/ppc/pmac.c
===================================================================
--- a/drivers/ide/ppc/pmac.c
+++ b/drivers/ide/ppc/pmac.c
@@ -529,81 +529,6 @@ pmac_outbsync(ide_drive_t *drive, u8 val
}
/*
- * Send the SET_FEATURE IDE command to the drive and update drive->id with
- * the new state. We currently don't use the generic routine as it used to
- * cause various trouble, especially with older mediabays.
- * This code is sometimes triggering a spurrious interrupt though, I need
- * to sort that out sooner or later and see if I can finally get the
- * common version to work properly in all cases
- */
-static int
-pmac_ide_do_setfeature(ide_drive_t *drive, u8 command)
-{
- ide_hwif_t *hwif = HWIF(drive);
- int result;
- u8 stat;
-
- disable_irq_nosync(hwif->irq);
- udelay(1);
- SELECT_DRIVE(drive);
- SELECT_MASK(drive, 0);
- udelay(1);
- hwif->OUTB(drive->ctl | 2, IDE_CONTROL_REG);
- hwif->OUTB(command, IDE_NSECTOR_REG);
- hwif->OUTB(SETFEATURES_XFER, IDE_FEATURE_REG);
- hwif->OUTBSYNC(drive, WIN_SETFEATURES, IDE_COMMAND_REG);
- result = __ide_wait_stat(drive, drive->ready_stat,
- BUSY_STAT|DRQ_STAT|ERR_STAT,
- WAIT_CMD, &stat);
- if (result)
- printk(KERN_ERR "%s: pmac_ide_do_setfeature disk not ready "
- "after SET_FEATURE !\n", drive->name);
-
- SELECT_MASK(drive, 0);
- if (result == 0) {
- drive->id->dma_ultra &= ~0xFF00;
- drive->id->dma_mword &= ~0x0F00;
- drive->id->dma_1word &= ~0x0F00;
- switch(command) {
- case XFER_UDMA_7:
- drive->id->dma_ultra |= 0x8080; break;
- case XFER_UDMA_6:
- drive->id->dma_ultra |= 0x4040; break;
- case XFER_UDMA_5:
- drive->id->dma_ultra |= 0x2020; break;
- case XFER_UDMA_4:
- drive->id->dma_ultra |= 0x1010; break;
- case XFER_UDMA_3:
- drive->id->dma_ultra |= 0x0808; break;
- case XFER_UDMA_2:
- drive->id->dma_ultra |= 0x0404; break;
- case XFER_UDMA_1:
- drive->id->dma_ultra |= 0x0202; break;
- case XFER_UDMA_0:
- drive->id->dma_ultra |= 0x0101; break;
- case XFER_MW_DMA_2:
- drive->id->dma_mword |= 0x0404; break;
- case XFER_MW_DMA_1:
- drive->id->dma_mword |= 0x0202; break;
- case XFER_MW_DMA_0:
- drive->id->dma_mword |= 0x0101; break;
- case XFER_SW_DMA_2:
- drive->id->dma_1word |= 0x0404; break;
- case XFER_SW_DMA_1:
- drive->id->dma_1word |= 0x0202; break;
- case XFER_SW_DMA_0:
- drive->id->dma_1word |= 0x0101; break;
- default: break;
- }
- if (!drive->init_speed)
- drive->init_speed = command;
- drive->current_speed = command;
- }
- enable_irq(hwif->irq);
- return result;
-}
-
-/*
* Old tuning functions (called on hdparm -p), sets up drive PIO timings
*/
static void
@@ -684,7 +609,7 @@ pmac_ide_set_pio_mode(ide_drive_t *drive
drive->name, pio, *timings);
#endif
- if (pmac_ide_do_setfeature(drive, XFER_PIO + pio))
+ if (ide_config_drive_speed(drive, XFER_PIO + pio))
return;
pmac_ide_do_update_timings(drive);
@@ -947,7 +872,7 @@ static int pmac_ide_tune_chipset(ide_dri
if (ret)
return ret;
- ret = pmac_ide_do_setfeature(drive, speed);
+ ret = ide_config_drive_speed(drive, speed);
if (ret)
return ret;
Index: b/include/linux/ide.h
===================================================================
--- a/include/linux/ide.h
+++ b/include/linux/ide.h
@@ -1152,7 +1152,6 @@ extern void SELECT_MASK(ide_drive_t *, i
extern void QUIRK_LIST(ide_drive_t *);
extern int drive_is_ready(ide_drive_t *);
-int __ide_wait_stat(ide_drive_t *, u8, u8, unsigned long);
/*
* taskfile io for disks for now...and builds request from ide_ioctl
-
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
