Print an explicit warning when a device's UDMA mode is limited due to
a 40-wire cable being detected, so that users have some idea why their
device isn't running as fast as it should.
This moves the application of the drive's mode masks before the cable
rule, so that can tell whether the rate is being limited by the cable
and not the drive or controller.
I haven't tested whether the message actually shows up, as my system
isn't horked in this manner..
Signed-off-by: Robert Hancock <hancockr@xxxxxxx>
--- linux-2.6.20-rc6-mm3/drivers/ata/libata-core.c 2007-02-04 21:48:25.000000000 -0600
+++ linux-2.6.20-rc6-mm3edit/drivers/ata/libata-core.c 2007-02-09 21:04:14.000000000 -0600
@@ -3393,22 +3393,24 @@ static void ata_dev_xfermask(struct ata_
xfer_mask = ata_pack_xfermask(ap->pio_mask,
ap->mwdma_mask, ap->udma_mask);
+ /* drive modes available */
+ xfer_mask &= ata_pack_xfermask(dev->pio_mask,
+ dev->mwdma_mask, dev->udma_mask);
+ xfer_mask &= ata_id_xfermask(dev->id);
+
/* Apply cable rule here. Don't apply it early because when
* we handle hot plug the cable type can itself change.
+ * Unknown or 80 wire cables reported host side are checked
+ * drive side as well. Cases where we know a 40wire cable
+ * is used safely for 80 are not checked here.
*/
- if (ap->cbl == ATA_CBL_PATA40)
- xfer_mask &= ~(0xF8 << ATA_SHIFT_UDMA);
- /* Apply drive side cable rule. Unknown or 80 pin cables reported
- * host side are checked drive side as well. Cases where we know a
- * 40wire cable is used safely for 80 are not checked here.
- */
- if (ata_drive_40wire(dev->id) && (ap->cbl == ATA_CBL_PATA_UNK || ap->cbl == ATA_CBL_PATA80))
+ if ((xfer_mask & (0xF8 << ATA_SHIFT_UDMA)) &&
+ ((ap->cbl == ATA_CBL_PATA40) ||
+ (ata_drive_40wire(dev->id) &&
+ (ap->cbl == ATA_CBL_PATA_UNK || ap->cbl == ATA_CBL_PATA80)))) {
+ ata_dev_printk(dev, KERN_WARNING, "limited to UDMA2 due to 40-wire cable\n");
xfer_mask &= ~(0xF8 << ATA_SHIFT_UDMA);
-
-
- xfer_mask &= ata_pack_xfermask(dev->pio_mask,
- dev->mwdma_mask, dev->udma_mask);
- xfer_mask &= ata_id_xfermask(dev->id);
+ }
/*
* CFA Advanced TrueIDE timings are not allowed on a shared
-
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
