There are quite a few drivers and options for the DesignWare I2C adapter in the Kconfig. Grouping all of them under the I2C_DESIGNWARE_CORE. That makes the menuconfig a bit more easier to understand. Signed-off-by: Heikki Krogerus <heikki.krogerus@xxxxxxxxxxxxxxx> --- drivers/i2c/busses/Kconfig | 29 ++++++++++++++++++----------- 1 file changed, 18 insertions(+), 11 deletions(-) diff --git a/drivers/i2c/busses/Kconfig b/drivers/i2c/busses/Kconfig index a22f9125322a..027724358d28 100644 --- a/drivers/i2c/busses/Kconfig +++ b/drivers/i2c/busses/Kconfig @@ -559,28 +559,33 @@ config I2C_DAVINCI For details please see http://www.ti.com/davinci config I2C_DESIGNWARE_CORE - tristate + tristate "Synopsys DesignWare I2C adapter" select REGMAP + help + This option enables support for the Synopsys DesignWare I2C adapter. + This driver includes support for the I2C host on the Synopsys + Designware I2C adapter. + + To compile the driver as a module, choose M here: the module will be + called i2c-designware-core. + +if I2C_DESIGNWARE_CORE config I2C_DESIGNWARE_SLAVE bool "Synopsys DesignWare Slave" - depends on I2C_DESIGNWARE_CORE select I2C_SLAVE help If you say yes to this option, support will be included for the Synopsys DesignWare I2C slave adapter. - This is not a standalone module, this module compiles together with - i2c-designware-core. - config I2C_DESIGNWARE_PLATFORM - tristate "Synopsys DesignWare Platform" + tristate "Synopsys DesignWare Platform driver" depends on (ACPI && COMMON_CLK) || !ACPI - select I2C_DESIGNWARE_CORE select MFD_SYSCON if MIPS_BAIKAL_T1 + default I2C_DESIGNWARE_CORE help If you say yes to this option, support will be included for the - Synopsys DesignWare I2C adapter. + Synopsys DesignWare I2C adapters on the platform bus. This driver can also be built as a module. If so, the module will be called i2c-designware-platform. @@ -613,17 +618,19 @@ config I2C_DESIGNWARE_BAYTRAIL a BayTrail system using the AXP288. config I2C_DESIGNWARE_PCI - tristate "Synopsys DesignWare PCI" + tristate "Synopsys DesignWare PCI driver" depends on PCI - select I2C_DESIGNWARE_CORE select I2C_CCGX_UCSI help If you say yes to this option, support will be included for the - Synopsys DesignWare I2C adapter. Only master mode is supported. + Synopsys DesignWare I2C adapters on the PCI bus. Only master mode is + supported. This driver can also be built as a module. If so, the module will be called i2c-designware-pci. +endif + config I2C_DIGICOLOR tristate "Conexant Digicolor I2C driver" depends on ARCH_DIGICOLOR || COMPILE_TEST -- 2.45.2
