Add support for PERIC0 clocks. Use them for USI in serial and I2C
configurations. Tested the serial at different baudrates (115200,
1M, 3M) and the I2C with an at24 eeprom, all went fine.
Apart of the DT and defconfig changes, the patch set spans through the tty
and clk subsystems. The expectation is that Krzysztof will apply the whole
series through the Samsung SoC tree. If the tty and clk subsystem
maintainers can give an acked-by or reviewed-by on the relevant patches
that would be most appreciated!
Thanks!
ta
Tudor Ambarus (13):
dt-bindings: clock: google,gs101: fix CMU_TOP gate clock names
dt-bindings: clock: google,gs101-clock: add PERIC0 clock management
unit
dt-bindings: i2c: exynos5: add google,gs101-hsi2c compatible
dt-bindings: serial: samsung: gs101: make reg-io-width required
property
tty: serial: samsung: add gs101 earlycon support
clk: samsung: gs101: add support for cmu_peric0
clk: samsung: gs101: mark PERIC0 IP TOP gate clock as critical
arm64: dts: exynos: gs101: enable cmu-peric0 clock controller
arm64: dts: exynos: gs101: update USI UART to use peric0 clocks
arm64: dts: exynos: gs101: define USI8 with I2C configuration
arm64: dts: exynos: gs101: enable eeprom on gs101-oriole
arm64: defconfig: sync with savedefconfig
arm64: defconfig: make at24 eeprom builtin
.../bindings/clock/google,gs101-clock.yaml | 25 +-
.../devicetree/bindings/i2c/i2c-exynos5.yaml | 1 +
.../bindings/serial/samsung_uart.yaml | 4 +
.../boot/dts/exynos/google/gs101-oriole.dts | 18 +
arch/arm64/boot/dts/exynos/google/gs101.dtsi | 52 +-
arch/arm64/configs/defconfig | 146 ++--
drivers/clk/samsung/clk-gs101.c | 748 ++++++++++++++++--
drivers/tty/serial/samsung_tty.c | 11 +
include/dt-bindings/clock/google,gs101.h | 230 ++++--
9 files changed, 980 insertions(+), 255 deletions(-)
--
2.43.0.472.g3155946c3a-goog
