Hi Arnd, > You probably know this already, but just in case for clarification > these are two different things: Ah, yes. I mistyped VFIO. Shows that I am not really fluent with these terms. But as I spoke of paravirtualized later, I think I meant the right thing. > > > I2C transactions can have an arbitrary number of messages which can > > arbitrarily be read or write. As I understand the above, only one read, > > write or read-write transaction is supported. If that is the case, it > > would be not very much I2C but more SMBus. If my assumptions are true, > > we first need to decide if you want to go the I2C way or SMBus subset. > > This has come up in previous reviews already. I think it comes down > to the requirement that the virtio i2c protocol should allow passthrough > access to any client devices connected to a physical i2c bus on the host, > and this should ideally be independent of whether the host driver > exposes I2C_RDWR or I2C_SMBUS ioctl interface, or both. If a host driver supports I2C_RDWR (i.e. I2C bus transactions) it will support I2C_SMBUS (i.e. SMBus transactions), too. It can be emulated and host drivers just need to set I2C_FUNC_SMBUS_EMUL. With the notable excaption of zero length transfers. Some cannot do this, so they use I2C_FUNC_I2C | (I2C_FUNC_SMBUS_EMUL & ~I2C_FUNC_SMBUS_QUICK). The other way around is not possible, SMBus is a subset of I2C. > This can be done either by having both interface types in the transport, > or picking one of the two, and translating to the host interface type > in software. If you have I2C, you have SMBus as well. > As far as I understand me (please clarify), implementing only the smbus > subset would mean that we cannot communicate with all client devices, > while implementing both would add more complexity than the lower-level > protocol. Correct. You need to pick I2C if you want to support all devices. SMBus will give you only a lot of devices. > > Also, as I read it, a whole bus is para-virtualized to the guest, or? > > Wouldn't it be better to allow just specific devices on a bus? Again, I > > am kinda new to this, so I may have overlooked things. > > Do you mean just allowing a single device per bus (as opposed to > having multiple devices as on a real bus), or just allowing > a particular set of client devices that can be identified using > virtio specific configuration (as opposed to relying on device > tree or similar for probing). Both of these are valid questions that > have been discussed before, but that could be revisited. I am just thinking that a physical bus on the host may have devices that should be shared with the guest while other devices on the same bus should not be shared (PMIC!). I'd think this is a minimal requirement for security. I also wonder if it is possible to have a paravirtualized bus in the guest which has multiple devices from the host sitting on different physical busses there. But that may be the cherry on the top. All the best, Wolfram
Attachment:
signature.asc
Description: PGP signature
