Hook up the standard GPIO/pinctrl-based recovery support for this
driver.
Based on a patch "i2c: cadence: Recover bus after controller reset" by
Chirag Parekh in the Xilinx kernel Git tree, but simplified to make use
of more common code.
Cc: Chirag Parekh <chiragp@xxxxxxxxxx>
Signed-off-by: Robert Hancock <robert.hancock@xxxxxxxxxx>
---
drivers/i2c/busses/i2c-cadence.c | 4 ++++
1 file changed, 4 insertions(+)
diff --git a/drivers/i2c/busses/i2c-cadence.c b/drivers/i2c/busses/i2c-cadence.c
index c1bbc4caeb5c..d017bc64e759 100644
--- a/drivers/i2c/busses/i2c-cadence.c
+++ b/drivers/i2c/busses/i2c-cadence.c
@@ -178,6 +178,7 @@ enum cdns_i2c_slave_state {
* @clk: Pointer to struct clk
* @clk_rate_change_nb: Notifier block for clock rate changes
* @quirks: flag for broken hold bit usage in r1p10
+ * @rinfo: Structure holding recovery information.
* @ctrl_reg_diva_divb: value of fields DIV_A and DIV_B from CR register
* @slave: Registered slave instance.
* @dev_mode: I2C operating role(master/slave).
@@ -202,6 +203,7 @@ struct cdns_i2c {
struct clk *clk;
struct notifier_block clk_rate_change_nb;
u32 quirks;
+ struct i2c_bus_recovery_info rinfo;
#if IS_ENABLED(CONFIG_I2C_SLAVE)
u16 ctrl_reg_diva_divb;
struct i2c_client *slave;
@@ -752,6 +754,7 @@ static int cdns_i2c_process_msg(struct cdns_i2c *id, struct i2c_msg *msg,
/* Wait for the signal of completion */
time_left = wait_for_completion_timeout(&id->xfer_done, adap->timeout);
if (time_left == 0) {
+ i2c_recover_bus(adap);
cdns_i2c_master_reset(adap);
dev_err(id->adap.dev.parent,
"timeout waiting on completion\n");
@@ -1212,6 +1215,7 @@ static int cdns_i2c_probe(struct platform_device *pdev)
id->adap.retries = 3; /* Default retry value. */
id->adap.algo_data = id;
id->adap.dev.parent = &pdev->dev;
+ id->adap.bus_recovery_info = &id->rinfo;
init_completion(&id->xfer_done);
snprintf(id->adap.name, sizeof(id->adap.name),
"Cadence I2C at %08lx", (unsigned long)r_mem->start);
--
2.27.0
