Hi Wolfram,
Sorry, please forgive my carefulness, I wrongly sent the version that
did not clean up, resulting in missing the reporter's information and
some errors in formats.
On 2021/3/19 上午1:06, Wolfram Sang wrote:
On Fri, Mar 19, 2021 at 12:25:43AM +0800, 周琰杰 (Zhou Yanjie) wrote:
Only send "X1000_I2C_DC_STOP" when last byte, or it will cause
error when I2C write operation.
Any write operation? I wonder then why nobody noticed before?
The standard I2C communication should look like this:
Read:
device_addr + w, reg_addr, device_addr + r, data;
Write:
device_addr + w, reg_addr, data;
But without this patch, it looks like this:
Read:
device_addr + w, reg_addr, device_addr + r, data;
Write:
device_addr + w, reg_addr, device_addr + w, data;
This is clearly not correct.
When I added support for X1000 to this driver, the hardware used was
CU1000-Neo. On this hardware, there was an ADS7830 that communicated
through I2C, but the operation of ADS7830 only involved read operations,
so I was at that time failed to realize the problem with the write
operation.
In addition, because X1000 did not implement relatively complete support
in the mainline until the second half of 2020, there are still a large
number of users who are still using the old SDK (kernel 3.10 and
kernel4.4) provided by Ingenics, which may also be indirectly delayed
exposure of this problem.
- while ((i2c_sta & JZ4780_I2C_STA_TFNF) &&
- (i2c->wt_len > 0)) {
+ while ((i2c_sta & JZ4780_I2C_STA_TFNF) && (i2c->wt_len > 0)) {
This is a cosmetic change only IIUC. Shouldn't be in a bugfix.
My fault, I will remove it in the next version.
Thanks and best regards!
