Hi Randy, On Fri, Feb 05, 2021 at 04:56:47PM -0800, Randy Dunlap wrote: > On 2/5/21 5:25 AM, Sakari Ailus wrote: > > Document the use of the _DSE object for setting desirable power state > > during probe. > > > > Signed-off-by: Sakari Ailus <sakari.ailus@xxxxxxxxxxxxxxx> > > Reviewed-by: Tomasz Figa <tfiga@xxxxxxxxxxxx> > > --- > > Documentation/firmware-guide/acpi/index.rst | 1 + > > .../firmware-guide/acpi/low-power-probe.rst | 69 +++++++++++++++++++ > > 2 files changed, 70 insertions(+) > > create mode 100644 Documentation/firmware-guide/acpi/low-power-probe.rst > > > > > diff --git a/Documentation/firmware-guide/acpi/low-power-probe.rst b/Documentation/firmware-guide/acpi/low-power-probe.rst > > new file mode 100644 > > index 0000000000000..b96804d959a6c > > --- /dev/null > > +++ b/Documentation/firmware-guide/acpi/low-power-probe.rst > > @@ -0,0 +1,69 @@ > > +.. SPDX-License-Identifier: GPL-2.0 > > + > > +====================================== > > +Probing I²C devices in low power state > > +====================================== > > + > > +Introduction > > +============ > > + > > +In some cases it may be preferred to leave certain devices powered off for the > > +entire system bootup if powering on these devices has adverse side effects, > > +beyond just powering on the said device. > > + > > +How it works > > +============ > > > > Hi, > > Please don't use ============ underlines for all section levels. The sections under the title are intended to be on the same level. -- Regards, Sakari Ailus
