Move i2c_parse_fw_timings() to rcar_i2c_clock_calculate() to consolidate
timings calls in one place.
While here, replace hard coded values with standard bus frequency definitions.
Signed-off-by: Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx>
---
v3: new patch
drivers/i2c/busses/i2c-rcar.c | 18 +++++++++---------
1 file changed, 9 insertions(+), 9 deletions(-)
diff --git a/drivers/i2c/busses/i2c-rcar.c b/drivers/i2c/busses/i2c-rcar.c
index f1f915bfdb9d..a8a136e490fa 100644
--- a/drivers/i2c/busses/i2c-rcar.c
+++ b/drivers/i2c/busses/i2c-rcar.c
@@ -235,17 +235,20 @@ static int rcar_i2c_bus_barrier(struct rcar_i2c_priv *priv)
return i2c_recover_bus(&priv->adap);
}
-static int rcar_i2c_clock_calculate(struct rcar_i2c_priv *priv, struct i2c_timings *t)
+static int rcar_i2c_clock_calculate(struct rcar_i2c_priv *priv)
{
u32 scgd, cdf, round, ick, sum, scl, cdf_width;
unsigned long rate;
struct device *dev = rcar_i2c_priv_to_dev(priv);
+ struct i2c_timings i2c_t, *t = &i2c_t;
/* Fall back to previously used values if not supplied */
- t->bus_freq_hz = t->bus_freq_hz ?: 100000;
- t->scl_fall_ns = t->scl_fall_ns ?: 35;
- t->scl_rise_ns = t->scl_rise_ns ?: 200;
- t->scl_int_delay_ns = t->scl_int_delay_ns ?: 50;
+ t->bus_freq_hz = I2C_MAX_STANDARD_MODE_FREQ;
+ t->scl_fall_ns = 35;
+ t->scl_rise_ns = 200;
+ t->scl_int_delay_ns = 50;
+
+ i2c_parse_fw_timings(dev, &i2c_t, false);
switch (priv->devtype) {
case I2C_RCAR_GEN1:
@@ -920,7 +923,6 @@ static int rcar_i2c_probe(struct platform_device *pdev)
struct rcar_i2c_priv *priv;
struct i2c_adapter *adap;
struct device *dev = &pdev->dev;
- struct i2c_timings i2c_t = {0};
int ret;
/* Otherwise logic will break because some bytes must always use PIO */
@@ -957,8 +959,6 @@ static int rcar_i2c_probe(struct platform_device *pdev)
i2c_set_adapdata(adap, priv);
strlcpy(adap->name, pdev->name, sizeof(adap->name));
- i2c_parse_fw_timings(dev, &i2c_t, false);
-
/* Init DMA */
sg_init_table(&priv->sg, 1);
priv->dma_direction = DMA_NONE;
@@ -967,7 +967,7 @@ static int rcar_i2c_probe(struct platform_device *pdev)
/* Activate device for clock calculation */
pm_runtime_enable(dev);
pm_runtime_get_sync(dev);
- ret = rcar_i2c_clock_calculate(priv, &i2c_t);
+ ret = rcar_i2c_clock_calculate(priv);
if (ret < 0)
goto out_pm_put;
--
2.25.1
