On 24.02.20 16:15, Andy Shevchenko wrote:
Since we have generic definitions for bus frequencies, let's use them.
Cc: Oleksij Rempel <linux@xxxxxxxxxxxxxxxx>
Cc: Shawn Guo <shawnguo@xxxxxxxxxx>
Cc: Sascha Hauer <s.hauer@xxxxxxxxxxxxxx>
Signed-off-by: Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx>
Acked-by: Oleksij Rempel <o.rempel@xxxxxxxxxxxxxx>
---
drivers/i2c/busses/i2c-imx.c | 5 +----
1 file changed, 1 insertion(+), 4 deletions(-)
diff --git a/drivers/i2c/busses/i2c-imx.c b/drivers/i2c/busses/i2c-imx.c
index a3b61336fe55..f5ed0f38904c 100644
--- a/drivers/i2c/busses/i2c-imx.c
+++ b/drivers/i2c/busses/i2c-imx.c
@@ -49,9 +49,6 @@
/* This will be the driver name the kernel reports */
#define DRIVER_NAME "imx-i2c"
-/* Default value */
-#define IMX_I2C_BIT_RATE 100000 /* 100kHz */
-
/*
* Enable DMA if transfer byte size is bigger than this threshold.
* As the hardware request, it must bigger than 4 bytes.\
@@ -1139,7 +1136,7 @@ static int i2c_imx_probe(struct platform_device *pdev)
goto rpm_disable;
/* Set up clock divider */
- i2c_imx->bitrate = IMX_I2C_BIT_RATE;
+ i2c_imx->bitrate = I2C_STANDARD_MODE_FREQ;
ret = of_property_read_u32(pdev->dev.of_node,
"clock-frequency", &i2c_imx->bitrate);
if (ret < 0 && pdata && pdata->bitrate)
Kind regards,
Oleksij Rempel
--
Pengutronix e.K. | |
Industrial Linux Solutions | http://www.pengutronix.de/ |
Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 |
Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 |
