From: Esben Haabendal <eha@xxxxxxxx> This fixes a race condition, where the DMAEN bit ends up being set after I2C slave has transmitted a byte following the dummy read. When that happens, an interrupt is generated instead, and no DMA request is generated to kickstart the DMA read, and a timeout happens after DMA_TIMEOUT (1 sec). Fixed by setting the DMAEN bit before the dummy read. Signed-off-by: Esben Haabendal <eha@xxxxxxxx> Acked-by: Uwe Kleine-König <u.kleine-koenig@xxxxxxxxxxxxxx> --- drivers/i2c/busses/i2c-imx.c | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-) diff --git a/drivers/i2c/busses/i2c-imx.c b/drivers/i2c/busses/i2c-imx.c index 498c5e891649..ad6adefb64da 100644 --- a/drivers/i2c/busses/i2c-imx.c +++ b/drivers/i2c/busses/i2c-imx.c @@ -668,9 +668,6 @@ static int i2c_imx_dma_read(struct imx_i2c_struct *i2c_imx, struct imx_i2c_dma *dma = i2c_imx->dma; struct device *dev = &i2c_imx->adapter.dev; - temp = imx_i2c_read_reg(i2c_imx, IMX_I2C_I2CR); - temp |= I2CR_DMAEN; - imx_i2c_write_reg(temp, i2c_imx, IMX_I2C_I2CR); dma->chan_using = dma->chan_rx; dma->dma_transfer_dir = DMA_DEV_TO_MEM; @@ -783,6 +780,7 @@ static int i2c_imx_read(struct imx_i2c_struct *i2c_imx, struct i2c_msg *msgs, bo int i, result; unsigned int temp; int block_data = msgs->flags & I2C_M_RECV_LEN; + int use_dma = i2c_imx->dma && msgs->len >= DMA_THRESHOLD && !block_data; dev_dbg(&i2c_imx->adapter.dev, "<%s> write slave address: addr=0x%x\n", @@ -809,12 +807,14 @@ static int i2c_imx_read(struct imx_i2c_struct *i2c_imx, struct i2c_msg *msgs, bo */ if ((msgs->len - 1) || block_data) temp &= ~I2CR_TXAK; + if (use_dma) + temp |= I2CR_DMAEN; imx_i2c_write_reg(temp, i2c_imx, IMX_I2C_I2CR); imx_i2c_read_reg(i2c_imx, IMX_I2C_I2DR); /* dummy read */ dev_dbg(&i2c_imx->adapter.dev, "<%s> read data\n", __func__); - if (i2c_imx->dma && msgs->len >= DMA_THRESHOLD && !block_data) + if (use_dma) return i2c_imx_dma_read(i2c_imx, msgs, is_lastmsg); /* read data */ -- 2.18.0
