From: Esben Haabendal <eha@xxxxxxxx> This fixes a race condition, where the DMAEN bit ends up being set after I2C slave has transmitted a byte following the dummy read. When that happens, an interrupt is generated instead, and no DMA request is generated to kickstart the DMA read, and a timeout happens after DMA_TIMEOUT (1 sec). Fixed by setting the DMAEN bit before the dummy read. Signed-off-by: Esben Haabendal <eha@xxxxxxxx> --- drivers/i2c/busses/i2c-imx.c | 5 ++--- 1 file changed, 2 insertions(+), 3 deletions(-) diff --git a/drivers/i2c/busses/i2c-imx.c b/drivers/i2c/busses/i2c-imx.c index 498c5e891649..f7bd6c21da27 100644 --- a/drivers/i2c/busses/i2c-imx.c +++ b/drivers/i2c/busses/i2c-imx.c @@ -668,9 +668,6 @@ static int i2c_imx_dma_read(struct imx_i2c_struct *i2c_imx, struct imx_i2c_dma *dma = i2c_imx->dma; struct device *dev = &i2c_imx->adapter.dev; - temp = imx_i2c_read_reg(i2c_imx, IMX_I2C_I2CR); - temp |= I2CR_DMAEN; - imx_i2c_write_reg(temp, i2c_imx, IMX_I2C_I2CR); dma->chan_using = dma->chan_rx; dma->dma_transfer_dir = DMA_DEV_TO_MEM; @@ -809,6 +806,8 @@ static int i2c_imx_read(struct imx_i2c_struct *i2c_imx, struct i2c_msg *msgs, bo */ if ((msgs->len - 1) || block_data) temp &= ~I2CR_TXAK; + if (i2c_imx->dma && msgs->len >= DMA_THRESHOLD && !block_data) + temp |= I2CR_DMAEN; imx_i2c_write_reg(temp, i2c_imx, IMX_I2C_I2CR); imx_i2c_read_reg(i2c_imx, IMX_I2C_I2DR); /* dummy read */ -- 2.18.0
