Re: [PATCH v3 1/1] at24: support eeproms that do not auto-rollover reads.

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Mon, Dec 04, 2017 at 05:24:33PM -0500, Sven Van Asbroeck wrote:
> > If this is truly specific to at24, then vendor prefix would be appropriate,
> > plus it'd go to an at24 specific binding file. However if it isn't I'd just
> > remove the above sentence. I guess the latter?
> 
> Yes, no-read-rollover is truly specific to at24.c, because it applies only
> to i2c multi-address chips. The at25 is spi based so cannot have multiple
> addresses.
> 
> So yes, "at24,no-read-rollover" would perhaps be a better name.
> 
> Regarding an at24 specific binding file. You're saying I should create
> Documentation/devicetree/bindings/eeprom/at24.txt ? Should I indicate
> that at24.txt "inherits from" eeprom.txt? Note that at25.txt does not
> currently do this.

Hmm. I actually missed we didn't have one to begin with. at25.txt exists
and it documents a number of properties specific to at25, so if at24 will
have an at24-specific property, then I think it should go to a separate
file.

Aren't there really other chips which need this? It'd be (a little bit)
easier to just remove the sentence. :-)

-- 
Regards,

Sakari Ailus
sakari.ailus@xxxxxxxxxxxxxxx



[Index of Archives]     [Linux GPIO]     [Linux SPI]     [Linux Hardward Monitoring]     [LM Sensors]     [Linux USB Devel]     [Linux Media]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]

  Powered by Linux