On Fri, Jun 17, 2016 at 2:03 PM, Jon Hunter <jonathanh@xxxxxxxxxx> wrote: > Add the DPAUX pinctrl states for the DPAUX nodes defining all three > possible states of "aux", "i2c" and "off". Also add the 'i2c-bus' > node for the DPAUX nodes so that the I2C driver core does not attempt > to parse the pinctrl state nodes. > > Populate the nodes for the pinctrl clients of the DPAUX pin controller. > There are two clients for each DPAUX instance, namely the SOR and one of > the I2C adapters. The SOR clients may used the DPAUX pins in either AUX > or I2C modes and so for these devices we don't define any of the generic > pinctrl states (default, idle, etc) because the SOR driver will directly > set the state needed. For I2C clients only the I2C mode is used and so > we can simplify matters by using the generic pinctrl states for default > and idle. > > Signed-off-by: Jon Hunter <jonathanh@xxxxxxxxxx> Acked-by: Linus Walleij <linus.walleij@xxxxxxxxxx> Yours Linus Walleij -- To unsubscribe from this list: send the line "unsubscribe linux-i2c" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
