The following patches are required to fix the existing driver to
support i2c on pistachio.
Tested on Pistachio bub using an Adafruit I2C Non-Volatile FRAM Breakout
(256Kbit / 32KByte) eeprom.
Used i2c buildroot tools to test the eeprom and the other i2c blocks.
Also used dd commands to copy data to and then to dump data from the
eeprom. i2ctransfer was used to test repeated starts and verified
using a scope.
Odeally these fixes should go in to Stable kernel (v3.19+).
Changes from v2:
5/7: Remove start bit detected not required, use line_status instead of i2c->line_status
7/7: use %u instead if %d for unsigned
Sifan Naeem (7):
i2c: img-scb: enable fencing for all versions of the ip
i2c: img-scb: do dummy writes before fifo access
i2c: img-scb: use DIV_ROUND_UP to round divisor values
i2c: img-scb: fix LOW and HIGH period values for the SCL clock
i2c: img-scb: use line_status instead of i2c->line_status
i2c: img-scb: Clear line and interrupt status before starting a
transfer
i2c: img-scb: verify support for requested bit rate
drivers/i2c/busses/i2c-img-scb.c | 73 ++++++++++++++++++++++----------------
1 file changed, 43 insertions(+), 30 deletions(-)
--
1.7.9.5
--
To unsubscribe from this list: send the line "unsubscribe linux-i2c" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
