Re: How to encode being an I2C slave in DT?

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hello,

On Tue, May 05, 2015 at 12:55:13PM +0200, Wolfram Sang wrote:
> So what about adding a new property "i2c-slave-reg"? This does not only
> prevent the confusion above, but also makes it very clear that this node
> is an I2C slave without the need to encode that somehow in the
> compatible property (although it probably should be described there as
> well, still).
I admit I didn't follow the discussions referenced in the footnotes, but
I wonder if the slave part should be added to the device tree at all.
AFAICT it could (and so should) be completely userspace-defined which
slave driver is used on which address. I imagine that for most
controllers the bus addresses to use can be chosen more or less freely.
So what am I missing?

> > I hope with this post I can join the different discussions somehow so we are 
> > able to find a common sense which is acceptable for all.
> 
> Thanks for doing this! I changed the subject to maybe raise interest a
> bit more.
that worked fine :-)

Best regards
Uwe

-- 
Pengutronix e.K.                           | Uwe Kleine-König            |
Industrial Linux Solutions                 | http://www.pengutronix.de/  |
--
To unsubscribe from this list: send the line "unsubscribe linux-i2c" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html




[Index of Archives]     [Linux GPIO]     [Linux SPI]     [Linux Hardward Monitoring]     [LM Sensors]     [Linux USB Devel]     [Linux Media]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]

  Powered by Linux