If the Designware core is configured with IC_EMPTYFIFO_HOLD_MASTER_EN set to zero, allowing the TX FIFO to become empty causes a STOP condition to be generated on the I2C bus. If the transmit FIFO threshold is set too high, an erroneous STOP condition can be generated on long transfers - particularly where the interrupt latency is extended. Signed-off-by: Andrew Jackson <Andrew.Jackson@xxxxxxx> Signed-off-by: Liviu Dudau <Liviu.Dudau@xxxxxxx> --- drivers/i2c/busses/i2c-designware-core.c | 2 +- 1 files changed, 1 insertions(+), 1 deletions(-) diff --git a/drivers/i2c/busses/i2c-designware-core.c b/drivers/i2c/busses/i2c-designware-core.c index 3c20e4b..e070edd 100644 --- a/drivers/i2c/busses/i2c-designware-core.c +++ b/drivers/i2c/busses/i2c-designware-core.c @@ -363,7 +363,7 @@ int i2c_dw_init(struct dw_i2c_dev *dev) } /* Configure Tx/Rx FIFO threshold levels */ - dw_writel(dev, dev->tx_fifo_depth - 1, DW_IC_TX_TL); + dw_writel(dev, dev->tx_fifo_depth / 2, DW_IC_TX_TL); dw_writel(dev, 0, DW_IC_RX_TL); /* configure the i2c master */ -- 1.7.1 -- To unsubscribe from this list: send the line "unsubscribe linux-i2c" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
