Hi José, On Mon, 09 Dec 2013 11:42:13 +0000, José Miguel Gonçalves wrote: > While testing an HIH6130 humidity and temperature sensor with I2C > interface in a BeagleBone board I've found that I was unable to read it > because the driver always returned EINVAL. With some debugging I've > found that the error was due to a test on omap_i2c_xfer_msg() in OMAP > I2C driver that invalidates zero length writes. The hwmon hih6130 driver > issues such kind of request in hih6130_update_measurements() to issue a > measurement request to the sensor. > > I was able to get measurements from the sensor by hacking the hih6130 > driver replacing the following line in hih6130_update_measurements(); > > ret = i2c_master_send(client, tmp, 0); > > by > > tmp[0] = 0; > ret = i2c_master_send(client, tmp, 1); > > Is this the correct way to fix this issue, or should the fix be in the > I2C OMAP driver to accept zero length transfers? Ideally it should be fixed in the i2c-omap bus driver. However, if zero-length transfers are explicitly prohibited, it may mean that the hardware itself can't do it (in which case adding a comment saying so in the source code would be great.) You'll have to check. The driver supports several generations of OMAP chipsets so you'll have to check them all, maybe some can handle zero-length messages and some do not. If fixing it in the i2c-omap driver is not possible, then working around it in the hih6130 driver would be acceptable. You'll have to make sure there is no side effect to sending a single byte to the chip. If performance is a concern, you may have to enable the workaround only when zero-byte messages aren't supported. You can check with: i2c_get_functionality(i2c_adapter) & I2C_FUNC_SMBUS_QUICK -- Jean Delvare -- To unsubscribe from this list: send the line "unsubscribe linux-i2c" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
