Per ICH10 datasheet [1] pg. 711, after completing a block transaction, INTR should be checked & cleared separately, only after BYTE_DONE is first cleared: When the last byte of a block message is received, the host controller sets DS. However, it does not set the INTR bit (and generate another interrupt) until DS is cleared. Thus, for a block message of n bytes, the ICH10 will generate n+1 interrupts. [1] http://www.intel.com/content/dam/doc/datasheet/io-controller-hub-10-family-datasheet.pdf Currently, the INTR bit was only checked & cleared separately if the PEC was used. This patch checks and clears INTR at the very end of every successful transaction, regardless of whether the PEC is used. Signed-off-by: Daniel Kurtz <djkurtz@xxxxxxxxxxxx> --- drivers/i2c/busses/i2c-i801.c | 46 ++++++++++++++++++++-------------------- 1 files changed, 23 insertions(+), 23 deletions(-) diff --git a/drivers/i2c/busses/i2c-i801.c b/drivers/i2c/busses/i2c-i801.c index 8b74e1e..6a53338 100644 --- a/drivers/i2c/busses/i2c-i801.c +++ b/drivers/i2c/busses/i2c-i801.c @@ -257,6 +257,24 @@ static int i801_check_post(struct i801_priv *priv, int status, int timeout) return result; } +/* wait for INTR bit as advised by Intel */ +static void i801_wait_intr(struct i801_priv *priv) +{ + int timeout = 0; + int status; + + status = inb_p(SMBHSTSTS(priv)); + while ((!(status & SMBHSTSTS_INTR)) && (timeout++ < MAX_RETRIES)) { + usleep_range(250, 500); + status = inb_p(SMBHSTSTS(priv)); + } + + if (timeout > MAX_RETRIES) + dev_dbg(&priv->pci_dev->dev, "INTR Timeout!\n"); + + outb_p(status, SMBHSTSTS(priv)); +} + static int i801_transaction(struct i801_priv *priv, int xact) { int status; @@ -281,26 +299,9 @@ static int i801_transaction(struct i801_priv *priv, int xact) if (result < 0) return result; - outb_p(SMBHSTSTS_INTR, SMBHSTSTS(priv)); - return 0; -} + i801_wait_intr(priv); -/* wait for INTR bit as advised by Intel */ -static void i801_wait_hwpec(struct i801_priv *priv) -{ - int timeout = 0; - int status; - - status = inb_p(SMBHSTSTS(priv)); - while ((!(status & SMBHSTSTS_INTR)) && (timeout++ < MAX_RETRIES)) { - usleep_range(250, 500); - status = inb_p(SMBHSTSTS(priv)); - } - - if (timeout > MAX_RETRIES) - dev_dbg(&priv->pci_dev->dev, "PEC Timeout!\n"); - - outb_p(status, SMBHSTSTS(priv)); + return 0; } static int i801_block_transaction_by_block(struct i801_priv *priv, @@ -416,9 +417,11 @@ static int i801_block_transaction_byte_by_byte(struct i801_priv *priv, outb_p(data->block[i+1], SMBBLKDAT(priv)); /* signals SMBBLKDAT ready */ - outb_p(SMBHSTSTS_BYTE_DONE | SMBHSTSTS_INTR, SMBHSTSTS(priv)); + outb_p(SMBHSTSTS_BYTE_DONE, SMBHSTSTS(priv)); } + i801_wait_intr(priv); + return 0; } @@ -474,9 +477,6 @@ static int i801_block_transaction(struct i801_priv *priv, read_write, command, hwpec); - if (result == 0 && hwpec) - i801_wait_hwpec(priv); - if (command == I2C_SMBUS_I2C_BLOCK_DATA && read_write == I2C_SMBUS_WRITE) { /* restore saved configuration register value */ -- 1.7.7.3 -- To unsubscribe from this list: send the line "unsubscribe linux-i2c" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
