Dear Sascha Hauer, > On Sat, Jun 09, 2012 at 01:11:42PM +0200, Marek Vasut wrote: > > Dear Sascha Hauer, > > > > > On Sat, Jun 09, 2012 at 12:34:47PM +0200, Marek Vasut wrote: > > > > Dear Shubhrajyoti Datta, > > > > > > > > > Didnt understand this. > > > > > > > > What exactly, it's running (according to the datasheet) at 95kHz. > > > > > > > > > > + .timing0 = 0x00780030, > > > > > > + .timing1 = 0x00800030, > > > > > > + .timing2 = 0x0015000d, > > > > > > +}; > > > > > > + > > > > > > +const struct mxs_i2c_speed_config mxs_i2c_400kHz_config = { > > > > > > + .timing0 = 0x000f0007, > > > > > > + .timing1 = 0x001f000f, > > > > > > + .timing2 = 0x0015000d, > > > > > > +}; > > > > > > + > > > > > > > > > > How are these values calculated? > > > > > > > > They're not calculated, they're presented in the datasheet. There's > > > > no formula, even though I believe one could be derived given enough > > > > effort. > > > > > > Don't these values depend on the input clock of this unit? I don't > > > know, just asking. > > > > Isn't the i2c block supplied from 24MHz clock source in the mx28? > > Maybe. Shouldn't this be checked then or at least mentioned that these > values assume a certain clock frequency? 27.5.2 - 27.5.4 in the MX28 TRM -- these values are for 24MHz clock indeed. > I wonder that currently the timing registers are not initialized at all. > Do they depend on reset defaults or bootloader setup? They're set to default values in our case -- I dunno if your bootloader always sets them up differently. > Sascha Best regards, Marek Vasut -- To unsubscribe from this list: send the line "unsubscribe linux-i2c" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html