Hey list I needed to bit bang I2C on an ancient MPC875 running at a blazing 50 MHz. I started by initializing the generic i2c-gpio bus but quickly found it could not bit bang @ 100 kHz. The most I was able to get it was ~50 kHz by setting udelay to 0 and patching around i2c-gpio.c to make sure it doesn't modify this value. I then implemented a bus driver of my own, based on i2c-gpio. The only difference was that it simply implemented set/get sda/scl by directly writing to hardware. Using this I was able to reach around 150 kHz. 1) Any comments on the above? Could I have done something differently? 2) I thought perhaps a thin adapter could be implemented that exported a platform data structure holding callbacks: set sda/scl dir/val, get sda/scl. By registering such a bus driver and supplying these callbacks in the platform module, one could avoid having to re-implement a bus driver like I did. Comments? Thanks Eran -- To unsubscribe from this list: send the line "unsubscribe linux-i2c" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
