On 7/4/23 09:14, Greg Kroah-Hartman wrote:
On Tue, Jul 04, 2023 at 07:14:54AM -0700, Guenter Roeck wrote:
On 7/4/23 06:44, Greg Kroah-Hartman wrote:
On Tue, Jul 04, 2023 at 06:39:07AM -0700, Guenter Roeck wrote:
On 7/4/23 06:17, Greg Kroah-Hartman wrote:
Drivers should not have a single static variable for the type of device
they are bound to. While this driver is really going to only have one
device at a time in the system, remove the static variable and instead,
look up the device type when needed.
This is expensive. I think it would be much better to just move
the board type detection into the init code and not instantiate
the driver in the fist place if the board type is unknown.
The board type detection is all over the place in the driver, it's not
just for "unknown" types, so how about just saving the board type at
probe time and using it then for all other places?
I must be missing something. The current code detects the board type
only once, in the probe function. Otherwise the static variable is used.
You are replacing it with repeated calls to get_board_type().
The whole point of the static variable is to avoid the cost of repeated
calls to dmi_first_match().
Ah, ok, yes, I was refering to the fact that the driver relies on the
detection of the device type in lots of different places (and doesn't
ever error out from the detection call.)
I am lost again. Current code:
dmi_entry = dmi_first_match(dmi_table);
if (!dmi_entry || boot_cpu_data.x86_vendor != X86_VENDOR_AMD)
return -ENODEV;
We can handle the static variable separately if it really bothers
you that much.
I did this change to make patch 2/3 more "obvious" what is happening
when the in_visible() callback happens, so that you don't have to worry
about the saved value or not. But this whole patch isn't really needed
if you don't mind the lookup just happening in the in_visible() callback
for the first time.
That would at least be a minimal change, and just add one extra lookup
which is only called once (or zero, if it is used to save the board type).
Ok, I'll switch it up, but really, it's just a simple table lookup loop,
and none of the detection calls are on a "hot path" that I can
determine. Or am I missing something?
As I said, my solution would be to move the board type detection
into the init function and not instantiate the driver in the first
place if the probe function would bail out anyway.
That's not the case today, the only way the probe function would fail
today is if the registering of the sysfs files fail. It does not matter
if the board detection call passes or not.
Again,
dmi_entry = dmi_first_match(dmi_table);
if (!dmi_entry || boot_cpu_data.x86_vendor != X86_VENDOR_AMD)
return -ENODEV;
^^^^^^^^^^^^^^^
What am I missing ?
Guenter
