Is there anything I can do to help getting the support for NCT6799D? Also, is it normal that I don't see any sensors after loading NCT6686D? Thanks, Jurgen. May 19, 2023, 2:51 PM by jurgenacc@xxxxxxxxxxxx: > My bad. I'm relatively new to Linux. This is the output of the "sensors" command: > > amdgpu-pci-0300 > Adapter: PCI adapter > vddgfx: 825.00 mV > fan1: 0 RPM (min = 0 RPM, max = 3300 RPM) > edge: +34.0°C (crit = +100.0°C, hyst = -273.1°C) > (emerg = +105.0°C) > junction: +38.0°C (crit = +110.0°C, hyst = -273.1°C) > (emerg = +115.0°C) > mem: +38.0°C (crit = +100.0°C, hyst = -273.1°C) > (emerg = +105.0°C) > PPT: 38.00 W (cap = 303.00 W) > > k10temp-pci-00c3 > Adapter: PCI adapter > Tctl: +44.6°C > Tccd1: +35.8°C > Tccd2: +40.9°C > > nvme-pci-4700 > Adapter: PCI adapter > Composite: +40.9°C > > amdgpu-pci-5000 > Adapter: PCI adapter > vddgfx: 1.32 V > vddnb: 1.15 V > edge: +42.0°C > PPT: 46.25 W > > iwlwifi_1-virtual-0 > Adapter: Virtual device > temp1: +30.0°C > > nvme-pci-4f00 > Adapter: PCI adapter > Composite: +36.9°C (low = -273.1°C, high = +81.8°C) > (crit = +84.8°C) > Sensor 1: +36.9°C (low = -273.1°C, high = +65261.8°C) > Sensor 2: +42.9°C (low = -273.1°C, high = +65261.8°C) > > These are the same as before, so no new sensors. > > Thanks, > Jurgen. > > > May 19, 2023, 1:47 PM by linux@xxxxxxxxxxxx: > >> On Fri, May 19, 2023 at 03:59:34PM +0200, jurgenacc@xxxxxxxxxxxx wrote: >> >>> Hi, >>> >>> Loading the nct6683 did not give an error. However the sensors-detect gives the same output "Sorry, no sensors were detected." >>> >> ??? The sensors-detect command and kernel drivers have no relationship >> to each other. >> >> Question is if you see any sensors after loading the nct6683 driver. >> >> Guenter >> > >
