> On 5/10/22 01:09, Holger Brunck wrote:
> > Some lm90 devices can operate in a extended temperature mode, this
> > feature
>
> lm90 compatible ... mode. This ...
>
> > is now eanbled if the property is set in the corresponding device tree
>
> enabled
>
ok.
> > node.
> >
> > Signed-off-by: Holger Brunck <holger.brunck@xxxxxxxxxxxxxxxxx>
> > cc: Jean Delvare <jdelvare@xxxxxxxx>
> > cc: Guenter Roeck <linux@xxxxxxxxxxxx>
>
> Cc: isn't really necessary or useful to list maintainers; You might want to use
> the --cc option of git send-email instead. Also, if used, it should be "Cc:".
>
ok.
> For the subject, please use "hwmon: (lm90) ...".
>
ok, will change that.
> > ---
> > drivers/hwmon/lm90.c | 4 +++-
> > 1 file changed, 3 insertions(+), 1 deletion(-)
> >
> > diff --git a/drivers/hwmon/lm90.c b/drivers/hwmon/lm90.c index
> > 1c9493c70813..6cdbcfab9f20 100644
> > --- a/drivers/hwmon/lm90.c
> > +++ b/drivers/hwmon/lm90.c
> > @@ -1707,6 +1707,7 @@ static void lm90_restore_conf(void *_data)
> >
> > static int lm90_init_client(struct i2c_client *client, struct lm90_data *data)
> > {
> > + struct device_node *np = client->dev.of_node;
> > int config, convrate;
> >
> > convrate = lm90_read_reg(client, LM90_REG_R_CONVRATE); @@
> > -1727,7 +1728,8 @@ static int lm90_init_client(struct i2c_client
> > *client, struct lm90_data *data)
> >
> > /* Check Temperature Range Select */
> > if (data->flags & LM90_HAVE_EXTENDED_TEMP) {
> > - if (config & 0x04)
> > + if (config & 0x04 ||
> > + of_property_read_bool(np,
> > + "onsemi,extended-range-enable"))
> > data->flags |= LM90_FLAG_ADT7461_EXT;
>
> Maybe I am missing something, but I don't see the matching configuration
> change. Specifying the flag in devicetree only really makes sense if the chip
> configuration is changed accordingly.
>
oops you are absolutely right I missed that. I didn't saw this in my test as
the config was still present from the previous run with my old kernel were
this was hard coded and the config survived after warm start.
Best regards
Holger
