[PATCH v2 08/21] docs: hwmon: w83791d: convert to ReST format

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Convert w83791d to ReST format, in order to allow it to
be parsed by Sphinx.

Signed-off-by: Mauro Carvalho Chehab <mchehab+samsung@xxxxxxxxxx>
---
 Documentation/hwmon/w83791d | 123 +++++++++++++++++++++---------------
 1 file changed, 71 insertions(+), 52 deletions(-)

diff --git a/Documentation/hwmon/w83791d b/Documentation/hwmon/w83791d
index f4021a285460..a91f9e5fb0c6 100644
--- a/Documentation/hwmon/w83791d
+++ b/Documentation/hwmon/w83791d
@@ -2,9 +2,13 @@ Kernel driver w83791d
 =====================
 
 Supported chips:
+
   * Winbond W83791D
+
     Prefix: 'w83791d'
+
     Addresses scanned: I2C 0x2c - 0x2f
+
     Datasheet: http://www.winbond-usa.com/products/winbond_products/pdfs/PCIC/W83791D_W83791Gb.pdf
 
 Author: Charles Spirakis <bezaur@xxxxxxxxx>
@@ -12,39 +16,46 @@ Author: Charles Spirakis <bezaur@xxxxxxxxx>
 This driver was derived from the w83781d.c and w83792d.c source files.
 
 Credits:
+
   w83781d.c:
-    Frodo Looijaard <frodol@xxxxxx>,
-    Philip Edelbrock <phil@xxxxxxxxxxxxx>,
-    and Mark Studebaker <mdsxyz123@xxxxxxxxx>
+
+    - Frodo Looijaard <frodol@xxxxxx>,
+    - Philip Edelbrock <phil@xxxxxxxxxxxxx>,
+    - Mark Studebaker <mdsxyz123@xxxxxxxxx>
+
   w83792d.c:
-    Shane Huang (Winbond),
-    Rudolf Marek <r.marek@xxxxxxxxxxxx>
+
+    - Shane Huang (Winbond),
+    - Rudolf Marek <r.marek@xxxxxxxxxxxx>
 
 Additional contributors:
-    Sven Anders <anders@xxxxxxxxxx>
-    Marc Hulsman <m.hulsman@xxxxxxxxxx>
+
+    - Sven Anders <anders@xxxxxxxxxx>
+    - Marc Hulsman <m.hulsman@xxxxxxxxxx>
 
 Module Parameters
 -----------------
 
 * init boolean
-  (default 0)
-  Use 'init=1' to have the driver do extra software initializations.
-  The default behavior is to do the minimum initialization possible
-  and depend on the BIOS to properly setup the chip. If you know you
-  have a w83791d and you're having problems, try init=1 before trying
-  reset=1.
+    (default 0)
+
+    Use 'init=1' to have the driver do extra software initializations.
+    The default behavior is to do the minimum initialization possible
+    and depend on the BIOS to properly setup the chip. If you know you
+    have a w83791d and you're having problems, try init=1 before trying
+    reset=1.
 
 * reset boolean
-  (default 0)
-  Use 'reset=1' to reset the chip (via index 0x40, bit 7). The default
-  behavior is no chip reset to preserve BIOS settings.
+    (default 0)
+
+    Use 'reset=1' to reset the chip (via index 0x40, bit 7). The default
+    behavior is no chip reset to preserve BIOS settings.
 
 * force_subclients=bus,caddr,saddr,saddr
-  This is used to force the i2c addresses for subclients of
-  a certain chip. Example usage is `force_subclients=0,0x2f,0x4a,0x4b'
-  to force the subclients of chip 0x2f on bus 0 to i2c addresses
-  0x4a and 0x4b.
+    This is used to force the i2c addresses for subclients of
+    a certain chip. Example usage is `force_subclients=0,0x2f,0x4a,0x4b`
+    to force the subclients of chip 0x2f on bus 0 to i2c addresses
+    0x4a and 0x4b.
 
 
 Description
@@ -91,11 +102,11 @@ This file is used for both legacy and new code.
 
 The sysfs interface to the beep bitmask has migrated from the original legacy
 method of a single sysfs beep_mask file to a newer method using multiple
-*_beep files as described in .../Documentation/hwmon/sysfs-interface.
+`*_beep` files as described in `Documentation/hwmon/sysfs-interface`.
 
 A similar change has occurred for the bitmap corresponding to the alarms. The
 original legacy method used a single sysfs alarms file containing a bitmap
-of triggered alarms. The newer method uses multiple sysfs *_alarm files
+of triggered alarms. The newer method uses multiple sysfs `*_alarm` files
 (again following the pattern described in sysfs-interface).
 
 Since both methods read and write the underlying hardware, they can be used
@@ -116,46 +127,54 @@ User mode code requesting values more often will receive cached values.
 The sysfs-interface is documented in the 'sysfs-interface' file. Only
 chip-specific options are documented here.
 
-pwm[1-3]_enable -	this file controls mode of fan/temperature control for
+======================= =======================================================
+pwm[1-3]_enable		this file controls mode of fan/temperature control for
 			fan 1-3. Fan/PWM 4-5 only support manual mode.
-		            * 1 Manual mode
-		            * 2 Thermal Cruise mode
-		            * 3 Fan Speed Cruise mode (no further support)
 
-temp[1-3]_target -	defines the target temperature for Thermal Cruise mode.
+			    * 1 Manual mode
+			    * 2 Thermal Cruise mode
+			    * 3 Fan Speed Cruise mode (no further support)
+
+temp[1-3]_target	defines the target temperature for Thermal Cruise mode.
 			Unit: millidegree Celsius
 			RW
 
-temp[1-3]_tolerance -	temperature tolerance for Thermal Cruise mode.
+temp[1-3]_tolerance	temperature tolerance for Thermal Cruise mode.
 			Specifies an interval around the target temperature
 			in which the fan speed is not changed.
 			Unit: millidegree Celsius
 			RW
+======================= =======================================================
 
 Alarms bitmap vs. beep_mask bitmask
-------------------------------------
+-----------------------------------
+
 For legacy code using the alarms and beep_mask files:
 
-in0 (VCORE)  :  alarms: 0x000001 beep_mask: 0x000001
-in1 (VINR0)  :  alarms: 0x000002 beep_mask: 0x002000 <== mismatch
-in2 (+3.3VIN):  alarms: 0x000004 beep_mask: 0x000004
-in3 (5VDD)   :  alarms: 0x000008 beep_mask: 0x000008
-in4 (+12VIN) :  alarms: 0x000100 beep_mask: 0x000100
-in5 (-12VIN) :  alarms: 0x000200 beep_mask: 0x000200
-in6 (-5VIN)  :  alarms: 0x000400 beep_mask: 0x000400
-in7 (VSB)    :  alarms: 0x080000 beep_mask: 0x010000 <== mismatch
-in8 (VBAT)   :  alarms: 0x100000 beep_mask: 0x020000 <== mismatch
-in9 (VINR1)  :  alarms: 0x004000 beep_mask: 0x004000
-temp1        :  alarms: 0x000010 beep_mask: 0x000010
-temp2        :  alarms: 0x000020 beep_mask: 0x000020
-temp3        :  alarms: 0x002000 beep_mask: 0x000002 <== mismatch
-fan1         :  alarms: 0x000040 beep_mask: 0x000040
-fan2         :  alarms: 0x000080 beep_mask: 0x000080
-fan3         :  alarms: 0x000800 beep_mask: 0x000800
-fan4         :  alarms: 0x200000 beep_mask: 0x200000
-fan5         :  alarms: 0x400000 beep_mask: 0x400000
-tart1        :  alarms: 0x010000 beep_mask: 0x040000 <== mismatch
-tart2        :  alarms: 0x020000 beep_mask: 0x080000 <== mismatch
-tart3        :  alarms: 0x040000 beep_mask: 0x100000 <== mismatch
-case_open    :  alarms: 0x001000 beep_mask: 0x001000
-global_enable:  alarms: -------- beep_mask: 0x800000 (modified via beep_enable)
+=============  ========  ========= ==========================
+Signal         Alarms    beep_mask Obs
+=============  ========  ========= ==========================
+in0 (VCORE)    0x000001  0x000001
+in1 (VINR0)    0x000002  0x002000  <== mismatch
+in2 (+3.3VIN)  0x000004  0x000004
+in3 (5VDD)     0x000008  0x000008
+in4 (+12VIN)   0x000100  0x000100
+in5 (-12VIN)   0x000200  0x000200
+in6 (-5VIN)    0x000400  0x000400
+in7 (VSB)      0x080000  0x010000  <== mismatch
+in8 (VBAT)     0x100000  0x020000  <== mismatch
+in9 (VINR1)    0x004000  0x004000
+temp1          0x000010  0x000010
+temp2          0x000020  0x000020
+temp3          0x002000  0x000002  <== mismatch
+fan1           0x000040  0x000040
+fan2           0x000080  0x000080
+fan3           0x000800  0x000800
+fan4           0x200000  0x200000
+fan5           0x400000  0x400000
+tart1          0x010000  0x040000  <== mismatch
+tart2          0x020000  0x080000  <== mismatch
+tart3          0x040000  0x100000  <== mismatch
+case_open      0x001000  0x001000
+global_enable  -         0x800000  (modified via beep_enable)
+=============  ========  ========= ==========================
-- 
2.20.1





[Index of Archives]     [LM Sensors]     [Linux Sound]     [ALSA Users]     [ALSA Devel]     [Linux Audio Users]     [Linux Media]     [Kernel]     [Gimp]     [Yosemite News]     [Linux Media]

  Powered by Linux