RE: [PATCH V2] gpiolib: use dev_err() when gpiod_configure_flags failed

[Peng Fan <peng.fan@xxxxxxx>]

> Subject: Re: [PATCH V2] gpiolib: use dev_err() when gpiod_configure_flags
> failed
> 
> On Wed, Mar 20, 2024 at 11:07:40AM +0000, Peng Fan wrote:
> > > On Wed, Mar 20, 2024 at 9:25 AM Peng Fan (OSS)
> > > <peng.fan@xxxxxxxxxxx>
> > > wrote:
> 
> ...
> 
> > > > When gpio-ranges property was missed to be added in the gpio node,
> > > > using dev_err() to show an error message will helping to locate
> > > > issues easier.
> > >
> > > I'm not convinced, so not my call to approve / reject, but see a remark
> below.
> >
> > You mean dev_err not help or else?
> 
> Moving it to error level.
> Usually developers enable CONFIG_DEBUG_GPIO for these messages to
> appear.

But this is a error log. Let's leave this to gpio maintainers.

> 
> ...
> 
> > > >         ret = gpiod_configure_flags(desc, con_id, lookupflags, flags);
> > > >         if (ret < 0) {
> > > > -               dev_dbg(consumer, "setup of GPIO %s failed\n", con_id);
> > > > +               dev_err(consumer, "setup of GPIO %s failed: %d\n",
> > > > + con_id, ret);
> > > >                 gpiod_put(desc);
> > > >                 return ERR_PTR(ret);
> > >
> > > While at it, can you move it to be after the gpiod_put()?
> >
> > Does it matter?
> 
> Yes, the system gives resource back as soon as possible.

Got it.

Thanks,
Peng.

> 
> --
> With Best Regards,
> Andy Shevchenko
>