Re: [PATCH v2] gpio: 74x164: Enable output pins after registers are reset

[Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx>]

On Thu, Feb 29, 2024 at 07:24:09PM +0200, Arturas Moskvinas wrote:
> On 2/29/24 15:25, Bartosz Golaszewski wrote:
> > On Thu, Feb 29, 2024 at 1:23 PM Arturas Moskvinas
> > <arturas.moskvinas@xxxxxxxxx>  wrote:
> > > Chip outputs are enabled[1] before actual reset is performed[2] which might
> > > cause pin output value to flip flop if previous pin value was set to 1
> > > in chip.
> > > Fix that behavior by making sure chip is fully reset before all outputs are
> > > enabled.
> > > 
> > > Bartosz, does this look better?
> > ... if previous pin value was set to 1 period
> Andriy, Bartosz, is commit message ok?

LGTM! Please, send a v3 with it.

-- 
With Best Regards,
Andy Shevchenko