Re: [PATCH v2] gpio: 74x164: Enable output pins after registers are reset

[Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx>]

On Thu, Feb 29, 2024 at 10:45:56AM +0200, Arturas Moskvinas wrote:
> Chip outputs are enabled[1] before actual reset is performed[2] which might
> cause pin output value to flip flop if previous pin value was set to 1 in chip.
> Change fixes that behavior by making sure chip is fully reset before all outputs
> are enabled.
> 
> Flip-flop can be noticed when module is removed and inserted again and one of
> the pins was changed to 1 before removal. 100 microsecond flipping is
> noticeable on oscilloscope (100khz SPI bus).
> 
> For a properly reset chip - output is enabled around 100 microseconds (on 100khz
> SPI bus) later during probing process hence should be irrelevant behavioral
> change.

> [1] - https://elixir.bootlin.com/linux/v6.7.4/source/drivers/gpio/gpio-74x164.c#L130
> [2] - https://elixir.bootlin.com/linux/v6.7.4/source/drivers/gpio/gpio-74x164.c#L150

Please, convert these to be Link tags, so

at the end it will look like

Fixes:
Link: URL1 [1]
Link: URL2 [2]
Signed-off-by:

-- 
With Best Regards,
Andy Shevchenko