Re: [PATCH v2 01/33] arm64: dts: qcom: ipq6018-cp01-c1: correct blspi1 pins

[Konrad Dybcio <konrad.dybcio@xxxxxxxxxxxxxx>]

On 26.09.2022 09:43, Krzysztof Kozlowski wrote:
> When BLSPI1 (originally SPI0, later renamed in commit f82c48d46852
> ("arm64: dts: qcom: ipq6018: correct QUP peripheral labels")) was added,
> the device node lacked respective pin configuration assignment.   It
> used also blsp0_spi function but that was probably the same mistake as
> naming it SPI0.
> 
> Fixes: 5bf635621245 ("arm64: dts: ipq6018: Add a few device nodes")
> Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
> ---
Reviewed-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxxxxxx>

Konrad
>  arch/arm64/boot/dts/qcom/ipq6018-cp01-c1.dts | 4 +++-
>  1 file changed, 3 insertions(+), 1 deletion(-)
> 
> diff --git a/arch/arm64/boot/dts/qcom/ipq6018-cp01-c1.dts b/arch/arm64/boot/dts/qcom/ipq6018-cp01-c1.dts
> index 1ba2eca33c7b..afc2dc79767d 100644
> --- a/arch/arm64/boot/dts/qcom/ipq6018-cp01-c1.dts
> +++ b/arch/arm64/boot/dts/qcom/ipq6018-cp01-c1.dts
> @@ -37,6 +37,8 @@ &blsp1_i2c3 {
>  
>  &blsp1_spi1 {
>  	cs-select = <0>;
> +	pinctrl-0 = <&spi_0_pins>;
> +	pinctrl-names = "default";
>  	status = "okay";
>  
>  	flash@0 {
> @@ -57,7 +59,7 @@ i2c_1_pins: i2c-1-pins {
>  
>  	spi_0_pins: spi-0-pins {
>  		pins = "gpio38", "gpio39", "gpio40", "gpio41";
> -		function = "blsp0_spi";
> +		function = "blsp1_spi";
>  		drive-strength = <8>;
>  		bias-pull-down;
>  	};