Re: [PATCH V3 3/3] gpio: modepin: Add driver support for modepin GPIO controller

[Michal Simek <michal.simek@xxxxxxxxxx>]

On 9/22/21 12:21 PM, Bartosz Golaszewski wrote:
> On Wed, Sep 22, 2021 at 12:18 PM Bartosz Golaszewski
> <bgolaszewski@xxxxxxxxxxxx> wrote:
>>
>> On Mon, Aug 23, 2021 at 10:14 AM Michal Simek <michal.simek@xxxxxxxxxx> wrote:
>>>
>>> Hi Bart,
>>>
>>> On 8/23/21 10:02 AM, Bartosz Golaszewski wrote:
>>>> On Wed, Aug 18, 2021 at 10:11 AM Piyush Mehta <piyush.mehta@xxxxxxxxxx> wrote:
>>>>>
>>>>> This patch adds driver support for the zynqmp modepin GPIO controller.
>>>>> GPIO modepin driver set and get the value and status of the PS_MODE pin,
>>>>> based on device-tree pin configuration. These four mode pins are
>>>>> configurable as input/output. The mode pin has a control register, which
>>>>> have lower four-bits [0:3] are configurable as input/output, next four-bits
>>>>> can be used for reading the data  as input[4:7], and next setting the
>>>>> output pin state output[8:11].
>>>>>
>>>>> Signed-off-by: Piyush Mehta <piyush.mehta@xxxxxxxxxx>
>>>>> Acked-by: Michal Simek <michal.simek@xxxxxxxxxx>
>>>>> Reviewed-by: Linus Walleij <linus.walleij@xxxxxxxxxx>
>>>>> ---
>>>>
>>>> Which tree should this go through?
>>>
>>> I would prefer to go this via gpio tree.
>>>
>>> Thanks,
>>> Michal
>>
>> Sure, just make sure to get an Ack from Rob Herring on the DT bindings.
>>
>> Bart
> 
> Nevermind - it's already there.

yes. that's what I thought. :-)

Cheers,
Michal