Re: [PATCH V3 3/3] gpio: modepin: Add driver support for modepin GPIO controller

[Michal Simek <michal.simek@xxxxxxxxxx>]

Hi Bart,

On 8/23/21 10:02 AM, Bartosz Golaszewski wrote:
> On Wed, Aug 18, 2021 at 10:11 AM Piyush Mehta <piyush.mehta@xxxxxxxxxx> wrote:
>>
>> This patch adds driver support for the zynqmp modepin GPIO controller.
>> GPIO modepin driver set and get the value and status of the PS_MODE pin,
>> based on device-tree pin configuration. These four mode pins are
>> configurable as input/output. The mode pin has a control register, which
>> have lower four-bits [0:3] are configurable as input/output, next four-bits
>> can be used for reading the data  as input[4:7], and next setting the
>> output pin state output[8:11].
>>
>> Signed-off-by: Piyush Mehta <piyush.mehta@xxxxxxxxxx>
>> Acked-by: Michal Simek <michal.simek@xxxxxxxxxx>
>> Reviewed-by: Linus Walleij <linus.walleij@xxxxxxxxxx>
>> ---
> 
> Which tree should this go through?

I would prefer to go this via gpio tree.

Thanks,
Michal