Re: [PATCH v3 09/11] dt-bindings: pwm: Add binding for RPi firmware PWM bus

[Rob Herring <robh@xxxxxxxxxx>]

On Wed, 04 Nov 2020 11:39:35 +0100, Nicolas Saenz Julienne wrote:
> The PWM bus controlling the fan in RPi's official PoE hat can only be
> controlled by the board's co-processor.
> 
> Signed-off-by: Nicolas Saenz Julienne <nsaenzjulienne@xxxxxxx>
> Reviewed-by: Rob Herring <robh@xxxxxxxxxx>
> 
> ---
> 
> Changes since v1:
>  - Update bindings to use 2 #pwm-cells
> 
>  .../arm/bcm/raspberrypi,bcm2835-firmware.yaml | 20 +++++++++++++++++++
>  .../pwm/raspberrypi,firmware-pwm.h            | 13 ++++++++++++
>  2 files changed, 33 insertions(+)
>  create mode 100644 include/dt-bindings/pwm/raspberrypi,firmware-pwm.h
> 


My bot found errors running 'make dt_binding_check' on your patch:

yamllint warnings/errors:

dtschema/dtc warnings/errors:
/builds/robherring/linux-dt-review/Documentation/devicetree/bindings/arm/bcm/raspberrypi,bcm2835-firmware.example.dt.yaml: firmware: pwm:#pwm-cells:0:0: 2 was expected
	From schema: /builds/robherring/linux-dt-review/Documentation/devicetree/bindings/arm/bcm/raspberrypi,bcm2835-firmware.yaml


See https://patchwork.ozlabs.org/patch/1393804

The base for the patch is generally the last rc1. Any dependencies
should be noted.

If you already ran 'make dt_binding_check' and didn't see the above
error(s), then make sure 'yamllint' is installed and dt-schema is up to
date:

pip3 install dtschema --upgrade

Please check and re-submit.