Re: [PATCH v2 1/2] gpio/aspeed-sgpio: enable access to all 80 input & output sgpios

[Joel Stanley <joel@xxxxxxxxx>]

On Wed, 16 Sep 2020 at 11:09, Bartosz Golaszewski
<bgolaszewski@xxxxxxxxxxxx> wrote:
>
> On Wed, Sep 16, 2020 at 6:51 AM Joel Stanley <joel@xxxxxxxxx> wrote:
> >
> > Hi GPIO maintainers,
> >
> > On Fri, 11 Sep 2020 at 02:20, Joel Stanley <joel@xxxxxxxxx> wrote:
> > >
> > > On Fri, 11 Sep 2020 at 02:11, Jeremy Kerr <jk@xxxxxxxxxxxxxxxxxxxx> wrote:
> > > >
> > > > Currently, the aspeed-sgpio driver exposes up to 80 GPIO lines,
> > > > corresponding to the 80 status bits available in hardware. Each of these
> > > > lines can be configured as either an input or an output.
> > > >
> > > > However, each of these GPIOs is actually an input *and* an output; we
> > > > actually have 80 inputs plus 80 outputs.
> > > >
> > > > This change expands the maximum number of GPIOs to 160; the lower half
> > > > of this range are the input-only GPIOs, the upper half are the outputs.
> > > > We fix the GPIO directions to correspond to this mapping.
> > > >
> > > > This also fixes a bug when setting GPIOs - we were reading from the
> > > > input register, making it impossible to set more than one output GPIO.
> > > >
> > > > Signed-off-by: Jeremy Kerr <jk@xxxxxxxxxxxxxxxxxxxx>
> > > > Fixes: 7db47faae79b ("gpio: aspeed: Add SGPIO driver")
> > >
> > > Reviewed-by: Joel Stanley <joel@xxxxxxxxx>
> >
> > This series is good to go in for 5.10:
> >
>
> Hi Joel,
>
> I don't have this in my inbox. Did you copy me on this series?

I did not; I am not the author of the patches as you can see.

I notice that Jeremy sent them to the linux-gpio list, but you were
not copied. Are you able to grab them from lore, or do you need him to
resend them?

Cheers,

Joel