[PATCH RESEND v2 2/2] pinctrl: meson: wire up the gpio_chip's set_config callback

[Martin Blumenstingl <martin.blumenstingl@xxxxxxxxxxxxxx>]

Use gpiochip_generic_config for the gpio_chip's set_config callback so
GPIO flags like GPIO_PULL_UP or GPIO_PULL_DOWN can be used in the board
.dts descriptions.
This is required for some Meson8m2 boards where GPIO_BSD_EN provides the
"MUTE" signal and requires enabling the internal pull-up resistor.

Signed-off-by: Martin Blumenstingl <martin.blumenstingl@xxxxxxxxxxxxxx>
---
 drivers/pinctrl/meson/pinctrl-meson.c | 1 +
 1 file changed, 1 insertion(+)

diff --git a/drivers/pinctrl/meson/pinctrl-meson.c b/drivers/pinctrl/meson/pinctrl-meson.c
index 291f3078e7c7..079f8ee8d353 100644
--- a/drivers/pinctrl/meson/pinctrl-meson.c
+++ b/drivers/pinctrl/meson/pinctrl-meson.c
@@ -603,6 +603,7 @@ static int meson_gpiolib_register(struct meson_pinctrl *pc)
 	pc->chip.parent = pc->dev;
 	pc->chip.request = gpiochip_generic_request;
 	pc->chip.free = gpiochip_generic_free;
+	pc->chip.set_config = gpiochip_generic_config;
 	pc->chip.get_direction = meson_gpio_get_direction;
 	pc->chip.direction_input = meson_gpio_direction_input;
 	pc->chip.direction_output = meson_gpio_direction_output;
-- 
2.26.1