Re: [PATCH v3 2/2] touchscreen: goodix: define GPIO mapping for GPD P2 Max

[Peter Cai <peter@xxxxxxxxxxxx>]

On Mon, Mar 2, 2020 at 7:57 PM Bastien Nocera <hadess@xxxxxxxxxx> wrote:
>
> On Mon, 2019-09-02 at 20:43 +0800, Peter Cai wrote:
> > The firmware of GPD P2 Max could not handle panel resets although
> > code
> > is present in DSDT. The kernel needs to take on this job instead, but
> > the DSDT does not provide _DSD, rendering kernel helpless when trying
> > to
> > find the respective GPIO pins.
> >
> > Fortunately, this time GPD has proper DMI vendor / product strings
> > that
> > we could match against. We simply apply an acpi_gpio_mapping table
> > when
> > GPD P2 Max is matched.
> >
> > Additionally, the DSDT definition of the irq pin specifies a wrong
> > polarity. The new quirk introduced in the previous patch
> > (ACPI_GPIO_QUIRK_OVERRIDE_POLARITY) is applied to correct this.
>
> Hans has posted a patchset which reworks GPIO access for ACPI devices.
>
> Could you please check whether you could rebase your patch on top of
> that?
>
> I also think the comment in "Input: goodix - Add support for getting
> IRQ + reset GPIOs on Cherry Trail devices" might also be of use:
>
> +       case irq_pin_access_acpi_gpio:
> +               /*
> +                * The IRQ pin triggers on a falling edge, so its gets
> marked
> +                * as active-low, use output_raw to avoid the value
> inversion.
> +                */
>
> Cheers
>

Sorry I forgot to notify you earlier, but it turned out that the
manufacturer of the device has already applied a fix in their ACPI
table after this patch was submitted and discussed. This patch is no
longer needed.