[PATCH v1] pinctrl: baytrail: Move IRQ valid mask initialization to a dedicated callback

[Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx>]

There is a logical continuation of the commit 5fbe5b5883f8 ("gpio: Initialize
the irqchip valid_mask with a callback") to split IRQ initialization to
hardware and valid mask setup parts.

Signed-off-by: Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx>
---
 drivers/pinctrl/intel/pinctrl-baytrail.c | 25 ++++++++++--------------
 1 file changed, 10 insertions(+), 15 deletions(-)

diff --git a/drivers/pinctrl/intel/pinctrl-baytrail.c b/drivers/pinctrl/intel/pinctrl-baytrail.c
index beb26550c25f..08e2b940cc11 100644
--- a/drivers/pinctrl/intel/pinctrl-baytrail.c
+++ b/drivers/pinctrl/intel/pinctrl-baytrail.c
@@ -1432,22 +1432,10 @@ static void byt_init_irq_valid_mask(struct gpio_chip *chip,
 				    unsigned long *valid_mask,
 				    unsigned int ngpios)
 {
-	/*
-	 * FIXME: currently the valid_mask is filled in as part of
-	 * initializing the irq_chip below in byt_gpio_irq_init_hw().
-	 * when converting this driver to the new way of passing the
-	 * gpio_irq_chip along when adding the gpio_chip, move the
-	 * mask initialization into this callback instead. Right now
-	 * this callback is here to make sure the mask gets allocated.
-	 */
-}
-
-static int byt_gpio_irq_init_hw(struct gpio_chip *gc)
-{
-	struct byt_gpio *vg = gpiochip_get_data(gc);
+	struct byt_gpio *vg = gpiochip_get_data(chip);
 	struct device *dev = &vg->pdev->dev;
 	void __iomem *reg;
-	u32 base, value;
+	u32 value;
 	int i;
 
 	/*
@@ -1468,13 +1456,20 @@ static int byt_gpio_irq_init_hw(struct gpio_chip *gc)
 
 		value = readl(reg);
 		if (value & BYT_DIRECT_IRQ_EN) {
-			clear_bit(i, gc->irq.valid_mask);
+			clear_bit(i, valid_mask);
 			dev_dbg(dev, "excluding GPIO %d from IRQ domain\n", i);
 		} else if ((value & BYT_PIN_MUX) == byt_get_gpio_mux(vg, i)) {
 			byt_gpio_clear_triggering(vg, i);
 			dev_dbg(dev, "disabling GPIO %d\n", i);
 		}
 	}
+}
+
+static int byt_gpio_irq_init_hw(struct gpio_chip *gc)
+{
+	struct byt_gpio *vg = gpiochip_get_data(gc);
+	void __iomem *reg;
+	u32 base, value;
 
 	/* clear interrupt status trigger registers */
 	for (base = 0; base < vg->soc_data->npins; base += 32) {
-- 
2.23.0