Greg <greguu@xxxxxxxx> writes: > On Sun, 11 Nov 2018 at 09:55, Robert Jarzmik <robert.jarzmik@xxxxxxx> wrote: >> >> Greg <greguu@xxxxxxxx> writes: Ok Greg, I think I know now what is happening. Could you try to apply the patch below and report please ? Cheers. -- Robert [1] Patch --8>-- >From 1ad797ad5d116a8573102e27fceffa31b1b89395 Mon Sep 17 00:00:00 2001 From: Robert Jarzmik <robert.jarzmik@xxxxxxx> Date: Sun, 11 Nov 2018 12:20:25 +0100 Subject: [PATCH] gpio: pxa: fix legacy non pinctrl aware builds again As pointed out by Gregor, spitz keyboard matrix is broken, with or without CONFIG_PINCTRL set, quoting : "The gpio matrix keypard on the Zaurus C3x00 (see spitz.c) does not work properly. Noticeable are that rshift+c does nothing where as lshift+c creates C. Opposite it is for rshift+a vs lshift+a, here only rshift works. This affects a few other combinations using the rshift or lshift buttons." As a matter of fact, as for platform_data based builds CONFIG_PINCTRL=n is required for now (as opposed for devicetree builds where it should be set), this means gpio driver should change the direction, which is what was attempted by commit c4e5ffb6f224 ("gpio: pxa: fix legacy non pinctrl aware builds"). Unfortunately, the input case was inverted, and the direction change was never done. This wasn't seen up until now because the initial platform setup (MFP) was setting this direction. Yet in Gregory's case, the matrix-keypad driver changes back and forth the direction dynamically, and this is why he's the first to report it. Reported-by: Greg <greguu@xxxxxxxx> Fixes: c4e5ffb6f224 ("gpio: pxa: fix legacy non pinctrl aware builds") Signed-off-by: Robert Jarzmik <robert.jarzmik@xxxxxxx> --- drivers/gpio/gpio-pxa.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/drivers/gpio/gpio-pxa.c b/drivers/gpio/gpio-pxa.c index 63536655f274..501147c5f3ca 100644 --- a/drivers/gpio/gpio-pxa.c +++ b/drivers/gpio/gpio-pxa.c @@ -268,8 +268,8 @@ static int pxa_gpio_direction_input(struct gpio_chip *chip, unsigned offset) if (pxa_gpio_has_pinctrl()) { ret = pinctrl_gpio_direction_input(chip->base + offset); - if (!ret) - return 0; + if (ret) + return ret; } spin_lock_irqsave(&gpio_lock, flags); -- 2.11.0