Before querying a GPIO to determine its direction, the GPIO should be formally requested. This allows the GPIO driver to block access to unavailable GPIOs, which makes it easier for some drivers to support sparse GPIO maps. Signed-off-by: Timur Tabi <timur@xxxxxxxxxxxxxx> --- drivers/gpio/gpiolib.c | 11 +++++++++++ 1 file changed, 11 insertions(+) diff --git a/drivers/gpio/gpiolib.c b/drivers/gpio/gpiolib.c index 9568708..3b4e1e8 100644 --- a/drivers/gpio/gpiolib.c +++ b/drivers/gpio/gpiolib.c @@ -1202,6 +1202,14 @@ int gpiochip_add_data(struct gpio_chip *chip, void *data) struct gpio_desc *desc = &gdev->descs[i]; desc->gdev = gdev; + + if (chip->request) { + status = chip->request(chip, i); + if (status < 0) + /* The GPIO is unavailable, so skip it */ + continue; + } + /* * REVISIT: most hardware initializes GPIOs as inputs * (often with pullups enabled) so power usage is @@ -1227,6 +1235,9 @@ int gpiochip_add_data(struct gpio_chip *chip, void *data) */ set_bit(FLAG_IS_OUT, &desc->flags); } + + if (chip->free) + chip->free(chip, i); } #ifdef CONFIG_PINCTRL -- Qualcomm Datacenter Technologies, Inc. as an affiliate of Qualcomm Technologies, Inc. Qualcomm Technologies, Inc. is a member of the Code Aurora Forum, a Linux Foundation Collaborative Project. -- To unsubscribe from this list: send the line "unsubscribe linux-gpio" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html