Re: [PATCH 1/1] gpio: altera: Use handle_level_irq when configured as a level_high

[Andy Shevchenko <andy.shevchenko@xxxxxxxxx>]

On Fri, Feb 17, 2017 at 11:12 AM, Phil Reid <preid@xxxxxxxxxxxxxxxxx> wrote:
> When a threaded irq handler is chained attached to one of the gpio
> pins when configure for level irq the altera_gpio_irq_leveL_high_handler
> does not mask the interrupt while being handled by the chained irq.
> This resulting in the threaded irq not getting enough cycles to complete
> quickly enough before the irq was disabled as faulty.
> It looks like handle_level_irq should be used in this situation
> instead of handle_simple_irq.

> @@ -310,7 +310,8 @@ static int altera_gpio_probe(struct platform_device *pdev)
>         altera_gc->interrupt_trigger = reg;
>
>         ret = gpiochip_irqchip_add(&altera_gc->mmchip.gc, &altera_irq_chip, 0,
> -               handle_simple_irq, IRQ_TYPE_NONE);
> +               altera_gc->interrupt_trigger == IRQ_TYPE_LEVEL_HIGH ?
> +               handle_level_irq : handle_simple_irq, IRQ_TYPE_NONE);

AFAIK, handle_bad_irq() should be used here.

-- 
With Best Regards,
Andy Shevchenko
--
To unsubscribe from this list: send the line "unsubscribe linux-gpio" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html