On Wed, Nov 9, 2016 at 9:19 PM, Joel Stanley <joel@xxxxxxxxx> wrote: > On Thu, Nov 10, 2016 at 4:56 AM, Rob Herring <robh@xxxxxxxxxx> wrote: >> On Thu, Nov 03, 2016 at 01:07:57AM +1030, Andrew Jeffery wrote: >>> The Aspeed SoC Display Controller is presented as a syscon device to >>> arbitrate access by display and pinmux drivers. Video pinmux >>> configuration on fifth generation SoCs depends on bits in both the >>> System Control Unit and the Display Controller. >>> >>> Signed-off-by: Andrew Jeffery <andrew@xxxxxxxx> >>> --- >>> Documentation/devicetree/bindings/mfd/aspeed-gfx.txt | 17 +++++++++++++++++ >> >> The register space can't be split to 2 nodes? > > Do you mean splitting the GFX IP and enable register into two nodes? > > We can't. Pinmux needs to check bit 6 and 7 in GFX064, which is in the > middle the IP block: > > GFX060: CRT Control Register I > GFX064: CRT Control Register II > GFX068: CRT Status Register > GFX06C: CRT Misc Setting Register Okay. >>> +The Aspeed SoC Display Controller primarily does as its name suggests, but also >>> +participates in pinmux requests on the g5 SoCs. It is therefore considered a >>> +syscon device. >>> + >>> +Required properties: >>> +- compatible: "aspeed,ast2500-gfx", "syscon" >> >> I think perhaps we should drop the syscon here and the driver should >> just register as a syscon. > > We want the regmap to be present whenever the GFX driver or pinmux is > loaded. If we register it in pinmux but chose to not build in that > driver, we lack the regmap. Same for the case where a user builds in > the GFX driver and not pinmux. I think this means we want the syscon > compatible string, unless my understanding is wrong? Right. Acked-by: Rob Herring <robh@xxxxxxxxxx> Rob -- To unsubscribe from this list: send the line "unsubscribe linux-gpio" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html