Re: [PATCH] pinctrl: bcm2835: reduce GPPUD set-up time

[Linus Walleij <linus.walleij@xxxxxxxxxx>]

On Mon, Oct 31, 2016 at 2:21 PM, Stefan Wahren <stefan.wahren@xxxxxxxx> wrote:

> Since the BCM2835 datasheet doesn't exactly specify the set-up time for
> the GPIO Pull-up/down Clock Registers there was an assumption of 150 cycles
> at a clock rate of 1 MHz. During a discussion [1] in the Raspberry Pi forum
> it turns out that clock rate refers to the VPU which has a rate of 250 MHz.
> So we can reduce the delay to a sensible value and update the comment above.
>
> I tested this optimization with a Raspberry Pi B and a multimeter.
>
> [1] - https://www.raspberrypi.org/forums/viewtopic.php?f=72&t=163352
>
> Signed-off-by: Stefan Wahren <stefan.wahren@xxxxxxxx>

Patch applied with Eric's review tag.

Yours,
Linus Walleij
--
To unsubscribe from this list: send the line "unsubscribe linux-gpio" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html