[PATCH] pinctrl: bcm2835: reduce GPPUD set-up time

[Stefan Wahren <stefan.wahren@xxxxxxxx>]

Since the BCM2835 datasheet doesn't exactly specify the set-up time for
the GPIO Pull-up/down Clock Registers there was an assumption of 150 cycles
at a clock rate of 1 MHz. During a discussion [1] in the Raspberry Pi forum
it turns out that clock rate refers to the VPU which has a rate of 250 MHz.
So we can reduce the delay to a sensible value and update the comment above.

I tested this optimization with a Raspberry Pi B and a multimeter.

[1] - https://www.raspberrypi.org/forums/viewtopic.php?f=72&t=163352

Signed-off-by: Stefan Wahren <stefan.wahren@xxxxxxxx>
---
 drivers/pinctrl/bcm/pinctrl-bcm2835.c |   10 ++++++----
 1 file changed, 6 insertions(+), 4 deletions(-)

diff --git a/drivers/pinctrl/bcm/pinctrl-bcm2835.c b/drivers/pinctrl/bcm/pinctrl-bcm2835.c
index fa77165..b2dd278 100644
--- a/drivers/pinctrl/bcm/pinctrl-bcm2835.c
+++ b/drivers/pinctrl/bcm/pinctrl-bcm2835.c
@@ -917,12 +917,14 @@ static int bcm2835_pinconf_set(struct pinctrl_dev *pctldev,
 
 		bcm2835_gpio_wr(pc, GPPUD, arg & 3);
 		/*
-		 * Docs say to wait 150 cycles, but not of what. We assume a
-		 * 1 MHz clock here, which is pretty slow...
+		 * BCM2835 datasheet say to wait 150 cycles, but not of what.
+		 * But the VideoCore firmware delay for this operation
+		 * based nearly on the same amount of VPU cycles and this clock
+		 * runs at 250 MHz.
 		 */
-		udelay(150);
+		udelay(1);
 		bcm2835_gpio_wr(pc, GPPUDCLK0 + (off * 4), BIT(bit));
-		udelay(150);
+		udelay(1);
 		bcm2835_gpio_wr(pc, GPPUDCLK0 + (off * 4), 0);
 	} /* for each config */
 
-- 
1.7.9.5

--
To unsubscribe from this list: send the line "unsubscribe linux-gpio" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html