On Thu, Nov 3, 2016 at 1:07 AM, Andrew Jeffery <andrew@xxxxxxxx> wrote: > The Aspeed LPC Host Controller is presented as a syscon device to > arbitrate access by LPC and pinmux drivers. LPC pinmux configuration on > fifth generation SoCs depends on bits in both the System Control Unit > and the LPC Host Controller. > > Signed-off-by: Andrew Jeffery <andrew@xxxxxxxx> > --- > Documentation/devicetree/bindings/mfd/aspeed-lpchc.txt | 17 +++++++++++++++++ > 1 file changed, 17 insertions(+) > create mode 100644 Documentation/devicetree/bindings/mfd/aspeed-lpchc.txt > > diff --git a/Documentation/devicetree/bindings/mfd/aspeed-lpchc.txt b/Documentation/devicetree/bindings/mfd/aspeed-lpchc.txt > new file mode 100644 > index 000000000000..792651488c3d > --- /dev/null > +++ b/Documentation/devicetree/bindings/mfd/aspeed-lpchc.txt > @@ -0,0 +1,17 @@ > +* Device tree bindings for the Aspeed LPC Host Controller (LPCHC) I had to check the data sheet for that acronym. They call the registers LHC. I somewhat prefer that name, but if you're happy with it as-is then that's fine. I assume this is not an issue on the g4/ast2400? > + > +The LPCHC registers configure LPC behaviour between the BMC and the host > +system. The LPCHC also participates in pinmux requests on g5 SoCs and is > +therefore considered a syscon device. > + > +Required properties: > +- compatible: "aspeed,ast2500-lpchc", "syscon" > +- reg: contains offset/length value of the LPCHC memory > + region. > + > +Example: > + > +lpchc: lpchc@1e7890a0 { > + compatible = "aspeed,ast2500-lpchc", "syscon"; > + reg = <0x1e7890a0 0xc4>; Where's the 0xc4 come from? I can see 9 registers, which would mean the length should be 0x24? Cheers, Joel -- To unsubscribe from this list: send the line "unsubscribe linux-gpio" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html