There are bitmap_gather() and bitmap_scatter() that are factually reimplemented in the driver. Use better bitmap APIs where appropriate. Signed-off-by: Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx> --- drivers/pinctrl/pinctrl-cy8c95x0.c | 33 +++++++++++------------------- 1 file changed, 12 insertions(+), 21 deletions(-) diff --git a/drivers/pinctrl/pinctrl-cy8c95x0.c b/drivers/pinctrl/pinctrl-cy8c95x0.c index 970b6842b05b..d3f4e20d219f 100644 --- a/drivers/pinctrl/pinctrl-cy8c95x0.c +++ b/drivers/pinctrl/pinctrl-cy8c95x0.c @@ -137,7 +137,7 @@ static const struct dmi_system_id cy8c95x0_dmi_acpi_irq_info[] = { * @irq_trig_low: I/O bits affected by a low voltage level * @irq_trig_high: I/O bits affected by a high voltage level * @push_pull: I/O bits configured as push pull driver - * @shiftmask: Mask used to compensate for Gport2 width + * @map: Mask used to compensate for Gport2 width * @nport: Number of Gports in this chip * @gpio_chip: gpiolib chip * @driver_data: private driver data @@ -158,7 +158,7 @@ struct cy8c95x0_pinctrl { DECLARE_BITMAP(irq_trig_low, MAX_LINE); DECLARE_BITMAP(irq_trig_high, MAX_LINE); DECLARE_BITMAP(push_pull, MAX_LINE); - DECLARE_BITMAP(shiftmask, MAX_LINE); + DECLARE_BITMAP(map, MAX_LINE); unsigned int nport; struct gpio_chip gpio_chip; unsigned long driver_data; @@ -621,13 +621,8 @@ static int cy8c95x0_write_regs_mask(struct cy8c95x0_pinctrl *chip, int reg, int ret; /* Add the 4 bit gap of Gport2 */ - bitmap_andnot(tmask, mask, chip->shiftmask, MAX_LINE); - bitmap_shift_left(tmask, tmask, 4, MAX_LINE); - bitmap_replace(tmask, tmask, mask, chip->shiftmask, BANK_SZ * 3); - - bitmap_andnot(tval, val, chip->shiftmask, MAX_LINE); - bitmap_shift_left(tval, tval, 4, MAX_LINE); - bitmap_replace(tval, tval, val, chip->shiftmask, BANK_SZ * 3); + bitmap_scatter(tmask, mask, chip->map, MAX_LINE); + bitmap_scatter(tval, val, chip->map, MAX_LINE); for (unsigned int i = 0; i < chip->nport; i++) { /* Skip over unused banks */ @@ -652,19 +647,13 @@ static int cy8c95x0_read_regs_mask(struct cy8c95x0_pinctrl *chip, int reg, { DECLARE_BITMAP(tmask, MAX_LINE); DECLARE_BITMAP(tval, MAX_LINE); - DECLARE_BITMAP(tmp, MAX_LINE); int read_val; u8 bits; int ret; /* Add the 4 bit gap of Gport2 */ - bitmap_andnot(tmask, mask, chip->shiftmask, MAX_LINE); - bitmap_shift_left(tmask, tmask, 4, MAX_LINE); - bitmap_replace(tmask, tmask, mask, chip->shiftmask, BANK_SZ * 3); - - bitmap_andnot(tval, val, chip->shiftmask, MAX_LINE); - bitmap_shift_left(tval, tval, 4, MAX_LINE); - bitmap_replace(tval, tval, val, chip->shiftmask, BANK_SZ * 3); + bitmap_scatter(tmask, mask, chip->map, MAX_LINE); + bitmap_scatter(tval, val, chip->map, MAX_LINE); for (unsigned int i = 0; i < chip->nport; i++) { /* Skip over unused banks */ @@ -684,8 +673,7 @@ static int cy8c95x0_read_regs_mask(struct cy8c95x0_pinctrl *chip, int reg, } /* Fill the 4 bit gap of Gport2 */ - bitmap_shift_right(tmp, tval, 4, MAX_LINE); - bitmap_replace(val, tmp, tval, chip->shiftmask, MAX_LINE); + bitmap_gather(tval, val, chip->map, MAX_LINE); return 0; } @@ -1484,8 +1472,11 @@ static int cy8c95x0_probe(struct i2c_client *client) return PTR_ERR(chip->regmap); bitmap_zero(chip->push_pull, MAX_LINE); - bitmap_zero(chip->shiftmask, MAX_LINE); - bitmap_set(chip->shiftmask, 0, 20); + + /* Setup HW pins mapping */ + bitmap_fill(chip->map, MAX_LINE); + bitmap_clear(chip->map, 20, 4); + mutex_init(&chip->i2c_lock); if (dmi_first_match(cy8c95x0_dmi_acpi_irq_info)) { -- 2.43.0.rc1.1336.g36b5255a03ac