Re: [PATCH 10/11] net: macb: Add support for RP1's MACB variant

[Andrew Lunn <andrew@xxxxxxx>]

> +static unsigned int txdelay = 35;
> +module_param(txdelay, uint, 0644);

Networking does not like module parameters.

This is also unused in this patch! So i suggest you just delete it.

> +
>  /* This structure is only used for MACB on SiFive FU540 devices */
>  struct sifive_fu540_macb_mgmt {
>  	void __iomem *reg;
> @@ -334,7 +337,7 @@ static int macb_mdio_wait_for_idle(struct macb *bp)
>  	u32 val;
>  
>  	return readx_poll_timeout(MACB_READ_NSR, bp, val, val & MACB_BIT(IDLE),
> -				  1, MACB_MDIO_TIMEOUT);
> +				  100, MACB_MDIO_TIMEOUT);
>  }
  
Please take this patch out of the series, and break it up. This is one
patch, with a good explanation why you need 1->100.

>  static int macb_mdio_read_c22(struct mii_bus *bus, int mii_id, int regnum)
> @@ -493,6 +496,19 @@ static int macb_mdio_write_c45(struct mii_bus *bus, int mii_id,
>  	return status;
>  }
>  
> +static int macb_mdio_reset(struct mii_bus *bus)
> +{
> +	struct macb *bp = bus->priv;
> +
> +	if (bp->phy_reset_gpio) {
> +		gpiod_set_value_cansleep(bp->phy_reset_gpio, 1);
> +		msleep(bp->phy_reset_ms);
> +		gpiod_set_value_cansleep(bp->phy_reset_gpio, 0);
> +	}
> +
> +	return 0;
> +}
> +
>  static void macb_init_buffers(struct macb *bp)
>  {
>  	struct macb_queue *queue;
> @@ -969,6 +985,7 @@ static int macb_mii_init(struct macb *bp)
>  	bp->mii_bus->write = &macb_mdio_write_c22;
>  	bp->mii_bus->read_c45 = &macb_mdio_read_c45;
>  	bp->mii_bus->write_c45 = &macb_mdio_write_c45;
> +	bp->mii_bus->reset = &macb_mdio_reset;

This is one patch.

>  	snprintf(bp->mii_bus->id, MII_BUS_ID_SIZE, "%s-%x",
>  		 bp->pdev->name, bp->pdev->id);
>  	bp->mii_bus->priv = bp;
> @@ -1640,6 +1657,11 @@ static int macb_rx(struct macb_queue *queue, struct napi_struct *napi,
>  
>  		macb_init_rx_ring(queue);
>  		queue_writel(queue, RBQP, queue->rx_ring_dma);
> +#ifdef CONFIG_ARCH_DMA_ADDR_T_64BIT
> +		if (bp->hw_dma_cap & HW_DMA_CAP_64B)
> +			macb_writel(bp, RBQPH,
> +				    upper_32_bits(queue->rx_ring_dma));
> +#endif

How does this affect a disto kernel? Do you actually need the #ifdef?
What does bp->hw_dma_cap contain when CONFIG_ARCH_DMA_ADDR_T_64BIT is
not defined?

Again, this should be a patch of its own, with a good commit message.

Interrupt coalescing should be a patch of its own, etc.

    Andrew

---
pw-bot: cr